HP0-Y51試験無料問題集「HP Building HP SDN and FlexNetwork Solutions 認定」
Table of Acronyms
An administrator is setting up an EVI solution on four HP Comware switches. The switches reach each other on these IP address:
-Switch1= 10.1.1.1 -Switch2= 10 2.2 2 -Switch3= 10.3.3.3 -Switch4= 10.4.4.4
The administrator wants to make Switch1 and Switch2 potential EVI Network Discovery Protocol (ENDP) servers. What is the proper configuration on the Switch1 EVI tunnel interface?
An administrator is setting up an EVI solution on four HP Comware switches. The switches reach each other on these IP address:
-Switch1= 10.1.1.1 -Switch2= 10 2.2 2 -Switch3= 10.3.3.3 -Switch4= 10.4.4.4
The administrator wants to make Switch1 and Switch2 potential EVI Network Discovery Protocol (ENDP) servers. What is the proper configuration on the Switch1 EVI tunnel interface?
正解：B,D
解答を投票する
解説: (GoShiken メンバーにのみ表示されます)
A Company has APs that are deployed relatively close together. These APs are controlled by an HP Unified Wired-Wireless controller. Which setting helps to prevent the APs from interfering with each other while also letting the APs extend their coverage area if one of the AP fails?
正解：A
解答を投票する
An administrator has set up an HP BYOD solution for an HP MSM760 controller and its APs.
These are the specifications:
-Guests should only have to register and log in once After that, the guest device should be
automatically logged in. -User Access Manager (UAM) provides the portal in which guests register their own accounts. -The MSM760 is connected to a Comware switch, which redirects unregistered guests to the
UAM portal.
Currently guests can reach the portal, register for their accounts, and log in. However, guests report that they cannot reach the Internet after they log in. When the administrator asks the guests to disconnect from the wireless network and then connect again, they succeed in reaching the Internet.
What could fix this problem?
These are the specifications:
-Guests should only have to register and log in once After that, the guest device should be
automatically logged in. -User Access Manager (UAM) provides the portal in which guests register their own accounts. -The MSM760 is connected to a Comware switch, which redirects unregistered guests to the
UAM portal.
Currently guests can reach the portal, register for their accounts, and log in. However, guests report that they cannot reach the Internet after they log in. When the administrator asks the guests to disconnect from the wireless network and then connect again, they succeed in reaching the Internet.
What could fix this problem?
正解：A
解答を投票する
Table of Acronyms Refer to the exhibit.
An administrator is setting up MPLS Layer 2 VPN connections between several customer sites:
-Connection 1 = Customer site 1 to customer site 2 -Connection 2=Customer site 1 to customer site 3
On PE-1, interface GigabitEthernet1/0/1 connects to CE-1 at site 1. Which setup establishes the desired connections?
An administrator is setting up MPLS Layer 2 VPN connections between several customer sites:
-Connection 1 = Customer site 1 to customer site 2 -Connection 2=Customer site 1 to customer site 3
On PE-1, interface GigabitEthernet1/0/1 connects to CE-1 at site 1. Which setup establishes the desired connections?
正解：B
解答を投票する
Refer to the exhibit.
A company has an HP VAN SDN Controller that controls HP Provision switches. An SDN developer creates an application that needs to make many immediate decisions for handling traffic. The application is programmed to create rules such as those shown in the exhibit
Which change could improve performance by letting the hardware handle the flows?
A company has an HP VAN SDN Controller that controls HP Provision switches. An SDN developer creates an application that needs to make many immediate decisions for handling traffic. The application is programmed to create rules such as those shown in the exhibit
Which change could improve performance by letting the hardware handle the flows?
正解：D
解答を投票する