HPE6-A69試験無料問題集（60題）「HP Aruba Certified Switching Expert Written 認定」

出題：1

The customer is considering Implemented the following VSX configuration that will host an Aruba mobility cluster servicing 9000 dual stack employee devices.
The client's default gateways will be hosted on the VSX stack. The customer is seeking advice about how to ensure ArubaOS-CX VSX best practices have been applied.

What advice can you offer the customer? (Select two)

A. Agg-1 and Agg-2's hardware forwarding table profile should be changed to "L3-agg''.

B. The Keepalive interface should be changed to interface LAG2 so there is redundancy through the mobility cluster.

C. The -system-mac' of Agg-1 should be changed to an unused address from the unicast private address range

D. The vsx linkup-delay timer is unnecessarily high; it should be reduced to prevent excessive delay of packet forwarding when a VSX peer joins an existing master.

E. The keepalive subnet is misconfigured, it has an inappropriate address on Agg-1.

F. The ISL Bandwidth should be upgraded

正解：A,E 解答を投票する

出題：2

Refer to the exhibit.

Aruba CX 6300 switch has routes in three different VRFs as per the example above. The user needs to leak routes between VRF Secure and VRF Dev. and also between VRF default and VRF Dev The customer Is not able to establish routing between directly connected networks 10.100.50.0/24 and
10.102.26.0/24 Which statement is true regarding the routing troubleshooting?

A. Multi-protocol BGP routing needs to be defined for route leaking

B. Route Distinguisher needs to be set to 1 for default VRF.

C. Route leaking is supported between non-default VRFs only

D. Route leaking between default and non-default VRFs is supported with Aruba CX 8400.

正解：A 解答を投票する

出題：3

Refer to the exhibit.

Criteria
1. All outbound traffic to AS 64516 prefers Edge-2 to AS 64516
2. All other outbound traffic prefers Edge-1 to AS 64513
Given the customer connectivity depicted in the diagram which single change can be performed on Edge-2 to ensure the criteria are met?

A. Configure Edge-2 to set the local preference for specific routes originating from AS 64516 to 200 and all other routes from AS 64516 to 50

B. Configure Edge-2 to set the weight on specific routes specific to AS 64516 to 1.

C. Configure Edge-2 with a route-map to 'set as-path prepend"' to apply 64516 two times to the neighbor for AS 64516.

D. Configure Edge-2 to set ebgp-multihop 3 for the neighbor for AS 64516.

正解：B 解答を投票する

出題：4

ArubaOS-CX 8325 VSX configuration has a Tailed ISL link between the switches with keepalive status established. While troubleshooting the condition, what is the expected behavior of the VSX traffic flow in the current condition?

A. vsx tables are n sync

B. VSX nodes Keep forwarding traffic over its interfaces

C. VSX tables are out of sync

D. VSX protection state is OK

E. VSX peer is seen as down

正解：B 解答を投票する

出題：5

A customer would like to utilize some ArubaOS-CX 6300M switches to perform OSPF routing.

All ports are routed, and ECMP is enabled, with other default parameters for OSPF. What will be the result of traffic sent from CLIENT-A to CUENT-B?

A. Traffic will be SW3 -> SW-1 -> Sw-2 & SW3 -> SW-4 -> SW-2

B. Traffic win be SW3 -> SW-1 -> sw-2.

C. Traffic will be SW3 -> SW-4 -> SW-2.

D. Traffic will be SW3 -> SW-1 -> sw-4 -> SW-2

正解：D 解答を投票する

出題：6

An administrator has identified a denial of service attack that is stressing the management processor on the switch. Which actions can be applied to CoPP to mitigate the issue? (Select two.)

A. Set the processing priority

B. Create a policy that matches the payload of GRE traffic.

C. Regulate traffic from the OOBM Ethernet port

D. Apply multiple active polices for the classes of traffic

正解：C,D 解答を投票する

HPE6-A69試験無料問題集「HP Aruba Certified Switching Expert Written 認定」