JN0-648試験無料問題集（92題）「Juniper Enterprise Routing and Switching, Professional (JNCIP-ENT) 認定」

出題：1

Click the Exhibit button.

Referring to the exhibit, which statement is correct?

A. This router is an ABR.

B. This router is an ASBR.

C. This router originated the LSA.

D. This router is connected to 27 different areas.

正解：C 解答を投票する

出題：2

You are deploying IP phones in your Layer 2 network and are asked to ensure that the switch sends VLAN and CoS information to the IP phones automatically.
In this scenario, which protocol should be used?

A. LLDP_MED

B. LLDP

C. PoE

D. PoE+

正解：A 解答を投票する

出題：3

You receive the same 100.200.0/16 route from all four ISPs to which you are connected.
Referring to the exhibit, which ISP's route will be selected as active?

A. ISP-B

B. ISP-D

C. ISP-C

D. ISP-A

正解：D 解答を投票する

出題：4

Exhibit.

A router is attempting to form an OSPF neighborship with another router However, the OSPF neighborship fails to establish completely Referring to the exhibit, what is the problem?

A. There is an interface MTU mismatch

B. There is an interface subnet mask mismatch

C. There is an OSPF area mismatch

D. There is an interface type mismatch

正解：A 解答を投票する

出題：5

Click the Exhibit button.

You have configured and applied the policer shown in the exhibit to your Junos device.
Which statement is true in this scenario?

A. Traffic exceeding the committed-burst size will be marked with a loss priority of high.

B. Traffic exceeding the committed-burst size will be discarded.

C. Traffic exceeding the committed-information-rate will be rate limited.

D. Traffic exceeding the excess-burst size will be discarded.

正解：D 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：6

Which protocol is used for port-level access control and authentication?

A. IPsec

B. MD5

C. 802.1x

D. AES

正解：C 解答を投票する

出題：7

You notice a mass withdrawal of routes for some of the network hosts. You determine that the link on the ESI interface is down.
Which route type is used in this scenario?

A. Type 2

B. Type 1

C. Type 5

D. Type 3

正解：B 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：8

Exhibit.

Referring to the exhibit, which two statements are true with regards to deploying CoS? (Choose two.)

A. You should apply BA classifiers on the LAN-facing interfaces of the routers

B. You should apply MF classifiers on the point-to-point interfaces of the routers

C. You should apply BA classifiers on the point-to point interfaces of the routers.

D. You should apply MF classifiers on the LAN-facing interfaces of the routers

正解：C,D 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：9

Click the Exhibit button.

Referring to the exhibit, you must advertise the 100.0.0.0/16 routes from AS1 to AS2, but R2 is not advertising any BGP routes to R5.
Why is this happening in this scenario?

A. The IBGP routes are not active because the next hop is not reachable.

B. The IBGP routes will not be advertised because the AS path shows as incomplete.

C. The IBGP routes will not be advertised because you must use a policy to advertise IBGP routes.

D. The IBGP routes are not active and EBGP will advertise only active routes.

正解：D 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

JN0-648試験無料問題集「Juniper Enterprise Routing and Switching, Professional (JNCIP-ENT) 認定」