CEM試験無料問題集「AEE Certified Energy Manager (CEM) 認定」

At the end of a performance contract, who owns the equipment installed by the project?

Using the natural gas combustion efficiency tables in your workbook, find the combustion efficiency (based on higher-heating value) of a natural-gas-fired boiler if the excess air level is measured at 31.9% and the stack temperature rise is 187.8°C.

Air is heated from 10°C (dry bulb temperature) and 80% relative humidity to 32°C (dry bulb temperature).
What is the new relative humidity?

You can buy air compressor A for $15,000 or air compressor B for $6,000. Compressor A will cost $10,000 per year to operate. Compressor B will cost $11,500 per year to operate. If both air compressors have a 10- year life and your required return on investment is 12%, which air compressor has the lowest total life-cycle cost?

Which of the advantages listed below, makes an ice TES system more preferred over a water TES system, when a load shifting strategy is considered?

解説: (GoShiken メンバーにのみ表示されます)
A 25-kW motor, at full load, drives a centrifugal fan that produces 160,000 liters per second (l/s) of ventilation air. If the fan speed is reduced to a flow rate of 150,000 l/s, what is the new load on the motor?

If installed without ancillary equipment, photovoltaic power cells generate what type of power?

What type of heat transfer is reduced by adding insulation to the inside surface of a wall?

Which of the following is NOT a typical benefit of performance contracting from the building owner's perspective?

A compressed-air distribution system has one section that frequently has low pressure when demand for compressed air is high. How can you resolve the problem without increasing energy consumption?