6103試験無料問題集（68題）「Avaya ERS 8000 and Avaya VSP 9000 Implementation 認定」

出題：1

A customer is expressing concern about reliability for their single uplink connections to the wiring closet. The switches in the wiring closet support Distributed Multi-Link Trunking (DMLT).
What can be done so the Virtual Services Platform (VSP) 9000 can eliminate a single point of failure for the lowest cost?

A. Duplicate the trunk elements in software.

B. Configure multiple VSP 9000 switches using Split Multi-Link Trunking (SMLT).

C. Duplicate the trunks across separate modules using DMLT.

D. Add a second switch fabric module.

正解：C 解答を投票する

出題：2

Refer to the exhibit.

Simple Loop Prevention Protocol (SLPP) provides active protection against Layer 2 network loops on a per-VLAN basis. For the SLPP Tx process, the network administrator decides on which VLANs to enable SLPP. The hello packets are then replicated out all ports that are members of the SLPP-enabled VLAN.
Given the following information shown in the exhibit:
A = InterSwitch Trunk (IST)
B = Split MultiLink Trunk (SMLT)
# 1 VSP 9000
# 2 VSP 9000
# 3 ERS 4500
When setting up the SLPP Rx process, which configuration role is setup on VSP #1?

A. The VSP # 1 Rx process is enabled on all SMLT VLANs to monitor for the VSP # 2 SLPP packets.

B. The VSP #1 Rx process is enabled on port 3/1 and the IST ports to monitor for the VSP #2 SLPP packets.

C. The VSP #1 Rx process is enabled on all SMLT VLANs to monitor for the ERS #3 SLPP packets.

D. The VSP # 1 RX process is enabled on port 3/1 to monitor VSP # 1 and VSP #2 SLPP packets.

正解：B 解答を投票する

出題：3

A campus network requirement is to introduce Virtual Routing and Forwarding (VRF) in the existing Virtual Services Platform (VSP) 9000 core. The technician needs to configure VRF on the VSP 9000.
Which statement represents the proper order for configuring a new VRF?

A. Create a VRF, create a new VLAN, move the VLAN to the new VRF, and add an IP address.

B. Create a VRF, create a new VLAN, add an IP address, and move the VLAN to the new VRF.

C. Create a VRF, add an IP address, create a new VLAN, and move the VLAN to the new VRF.

D. Create a new VLAN, add an IP address, create a VRF, and move the VLAN to the new VRF.

正解：B 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：4

Which file on the internal flash of Avaya Virtual Services Platform 9000 is used to specify the primary and backup release names?

A. boot.cfg

B. releases.cfg

C. config.cfg

D. version.cfg

正解：C 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：5

While troubleshooting the VSP 9000 system, a technician notices that one port Link/Activity LED is blinking constantly or is nearly solid. This could be an indication of mis-configuration or high traffic volume.
Using the CLI, what is the logical first step in troubleshooting this situation?

A. Verify the port configuration parameters on the VSP 9000 system.

B. Verify that there is not a broadcast storm by mirroring the traffic on that port.

C. Verify the port configuration parameters on both ends of the connection.

D. Verify the cable type and connectors on both ends of the connection.

正解：C 解答を投票する

出題：6

The VSP9000 uses three distinct traffic management profiles, configured with the boot config flag fabric-profile command.
What is the default profile in the VSP9000?

A. Unicast Optimized

B. Multicast Optimized

C. Balanced Profile

D. None, the profile must be set

正解：C 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：7

Policy-based traffic policers and traffic shapers identify traffic using a policy (a contract). Traffic that conforms to this policy (a service contract) is guaranteed transmission, and nonconforming traffic is considered in violation.
Which two statements about how Policy-based policers and shapers treat violations are true? (Choose two.)

A. Both traffic policers and traffic shapers support the marking and re-marking of DSCP and 802.1p, using filter actions.

B. Policy based-shaping drop packets exceeding the peak rate.

C. Traffic shaper allows the traffic to exceed the line rate, whereas traffic policers prevent traffic from exceeding the line rate.

D. Traffic shapers buffer and shape traffic, whereas traffic policers discard or re-mark excess traffic.

E. Policing occur on ingress.

正解：B,D 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

6103試験無料問題集「Avaya ERS 8000 and Avaya VSP 9000 Implementation 認定」