300-440試験無料問題集「Cisco Designing and Implementing Cloud Connectivity 認定」

Explanation:

The process of configuring an SLA class to specify the maximum packet loss, packet latency, and jitter allowed on a connection using Cisco vManage involves several steps12.
Click Configuration, select Policies, and then select Add Policy: This is the first step where you navigate to the Policies section in the Configuration menu of Cisco vManage1.
Click SLA Class and then click New SLA Class List: In this step, you create a new SLA Class List1.
Select Criteria, select Loss, Latency and Jitter, and then click Add: After setting up the SLA Class List, you select the criteria for the SLA class. In this case, the criteria are Loss, Latency, and Jitter1.
Set values for Loss, Latency, Jitter, and App Probe Class: Finally, you set the values for Loss, Latency, Jitter, and App Probe Class1.
References :=
Information About Application-Aware Routing - Cisco
Policies Configuration Guide for vEdge Routers, Cisco SD-WAN Release 20

Explanation:
Step 1 = Click Configuration, select Templates, and then select Feature Templates. Step 2 = Click Add Template, select the device, and then click Basic Configuration. Step 3 = Shut down the tunnel and then remove the ISAKMP profile. Step 4 = Attach the IKEv2 profile and then run the no shutdown command on the tunnel.
The process of configuring a site-to-site IPsec VPN connection between an on-premises Cisco IOS XE router in Controller mode and AWS, and changing the IKE version from IKEv1 to IKEv2 in Cisco vManage involves several steps123.
Click Configuration, select Templates, and then select Feature Templates: This is the first step where you navigate to the Templates section in the Configuration menu of Cisco vManage1.
Click Add Template, select the device, and then click Basic Configuration: In this step, you add a new template for the device and proceed with the basic configuration1.
Shut down the tunnel and then remove the ISAKMP profile: Before changing the IKE version, you need to shut down the existing tunnel and remove the ISAKMP profile that is configured for IKEv12.
Attach the IKEv2 profile and then run the no shutdown command on the tunnel: Finally, you attach the newly created IKEv2 profile to the tunnel and bring the tunnel back up2.
References :=
Configuring Internet Key Exchange Version 2 (IKEv2) - Cisco
Switch from IKEv1 to IKEv2 on Cisco Routers - Cisco Community
Configure IOS-XE Site-to-Site VPN Connection to Amazon Web Services - Cisco Community

解説: (GoShiken メンバーにのみ表示されます)