300-625試験無料問題集（72題）「Cisco Implementing Cisco Storage Area Networking 認定」

出題：1

Which configuration is always required when running the setup utility on a Cisco MDS 9000 Series Switch?

A. active default gateway

B. management IP address

C. administrator password

D. active NTP server

正解：C 解答を投票する

出題：2

A storage network engineer must install and configure a new MDS switch in a data center network.
Which two statements about available choices during the MDS switch initial setup are correct?
(Choose two.)

A. The secure password standard is required.

B. The engineer does not have the choice to enable or disable full zoneset distribution.

C. The engineer can configure the default switch port trunk mode.

D. The engineer can choose what will be the administrator account.

E. The engineer can configure the default zone policy.

正解：D,E 解答を投票する

出題：3

Which two steps are mutual between Cisco secure boot and UEFI secure boot? (Choose two.)

A. operating system

B. bootloader

C. hardware anchor

D. kemel

E. microloader

正解：A,B 解答を投票する

出題：4

A domain ID conflict is detected on a switch. Which action resolves the issue in the shortest possible time after the preferred domain ID is changed to a static domain ID?

A. Enter the commands to complete a domain manager fast restart.

B. Enter the commands for a VSAN suspend / no-suspend.

C. Issue an fcdomain nondisruptive restart.

D. Issue an fcdomain disruptive restart.

正解：D 解答を投票する

出題：5

Which statement accurately describes the result of disabling restrictions on oversubscription ratios on Cisco MDS 9000 Series Fibre Channel switching modules?

A. QoS can be configured.

B. A port-group can contain a single port only.

C. The bandwidth allocated to shared ports is proportionate to the configured speed of the ports.

D. The bandwidth allocation of the shared ports is equal to the lowest configured bandwidth.

正解：C 解答を投票する

出題：6

A Cisco MDS Series Switch with the POAP feature boots and does not find the startup configuration. Which location is checked first when the switch enters POAP mode?

A. TFTP server where the necessary configuration files are downloaded

B. DHCP server to bootstrap the interface IP address, gateway, DNS server, and TFTP IP addresses

C. USB device that contains the software image files and the switch configuration file

D. HTTP server where the URL is used to download the software image

正解：C 解答を投票する

出題：7

A storage administrator is enabling DH-CHAP for the first time on a Fibre Channel fabric.
Which condition must the administrator consider while configuring this feature?

A. Enabling DH-CHAP protocol feature is unsupported on FCIP interfaces.

B. The MD5 hash must be used if TACACS+ or RADIUS authentication for FCSP is enabled.

C. NTP must be configured on all devices or the configuration fails.

D. All switches on the fabric must be configured for the same password.

正解：B 解答を投票する

300-625試験無料問題集「Cisco Implementing Cisco Storage Area Networking 認定」