350-080試験無料問題集（475題）「Cisco CCIE Data Center Written 認定」

出題：1

Which three options are types of iSCSI node names? (Choose three.)

A. network address authority

B. iSCSI unique identifier

C. iSCSI qualified name

D. extended qualified name

E. extended unique identifier

F. network qualified name

正解：A,C,E 解答を投票する

出題：2

Refer to the Exhibit.

Which statement is true?

A. If you ignore the warning and press Yes, the association fails because no MAC address is assigned.

B. The error is triggered when the service profile pn is being associated.

C. The service profile in organization IS-SecureESX10 is trying to be associated to chassis 1 blade 7.

D. The only way to fix the problem is to delete the service profile and start again with the proper MAC and WWPN pool association.

正解：A 解答を投票する

出題：3

DRAG DROP

正解：

出題：4

Which are valid statements about Cisco Virtual Interface Card (VIC)? (Choose two.)

A. vNICs are created using software on the host operating system.

B. The Cisco VIC can create an unlimited number of Virtual NICs.

C. The host operating system sees a vNIC as a physical PCIe device.

D. The host operating system sees a vNIC as a sub-interface of a primary NIC.

E. The Cisco VIC can create 1024 vNICs.

F. The number of vNICs on the Cisco VIC that can be created is determined by the number of chassis uplinks.

正解：C,F 解答を投票する

出題：5

OTV is a MAC-in-IP method that extends Layer 2 connectivity across a transport network infrastructure. Which three options are high-availability features? (Choose three.)

A. fast failure detection

B. added the track-adjacency-nexthop command to enable overlay route tracking

C. added support for Ipv6 unicast forwarding and multicast flooding across the OTV overlay

D. OTV fast convergence

E. added support for unicast cores using an adjacency server

正解：A,C,D 解答を投票する

出題：6

Virtual PortChannels (vPCs) allow links that are physically connected to two different Cisco switches to appear to a third downstream device as coming from a single device and as part of a single port channel. Which of the following are components of a Virtual PortChannel system? (Choose four)

A. A redundant 10 Gigabit Ethernet PortChannel called a peer link to carry traffic from one system to the other when needed

B. A Layer 3 Gigabit Ethernet link called peer-keepalive link to resolve dual-active scenarios

C. A management port that can be used as peer-keepalive link to resolve dual-active scenarios.

D. A dot1q trunk between the vPC peers

E. Two peer devices: the vPC peers of which one is primary and one is secondary and are part of a vPC domain.

F. vPC member ports forming the PortChannel

正解：A,B,E,F 解答を投票する

出題：7

Where can port profiles be applied to a virtual machine?

A. on VSM, VEM, and vCenter

B. on vCenter only

C. on the VSM only

D. on VSM and vCenter

E. on VSM and VEM

正解：B 解答を投票する

出題：8

DRAG DROP
Drag and drop feature on the left onto the appropriate business benefits on the right.

正解：

Explanation:
ETS Data Center Bridging Exchange (DCBX) Protocol Fiber Channel over Ethernet (FCoE) PFC Ref:Cisco White Paper Data Center Bridging

出題：9

What is the appliance port used to connect to in a Cisco Unified Computing System?

A. Fibre Channel storage

B. NFS storage

C. UCS chassis

D. UCS C-Series servers

E. Other fabric interconnect

正解：B 解答を投票する

出題：10

Server load balancing (SLB) is the process of deciding to which server a load-balancing device should send a client request for service.
Which predictors are supported on ACE in order to select the best server to fulfill a client request? (Choose three.)

A. Hash header: Selects the server by using a hash value based on the HTTP header name

B. Hash IP: Selects the server using a hash value based on the IP address

C. Hash URL: Selects the server by using a hash value based on the requested URL

D. Hash MA Selects the server by using a hash value based on either the source or destination MAC address, or both

E. Hash address: Selects the server by using a hash value based on either the source or destination IP address, or both

正解：A,C,E 解答を投票する

出題：11

Which two actions must be done before configuring iSCSI boot for a server? (Choose two.)

A. Zoning must be configured.

B. The operating system must be iBFT-compatible.

C. Boot parameters must be configured in the global group policy.

D. The storage array must be licensed for iSCSI boot.

E. IP subnet of iSCSI initiator has to be in the same subnet as that of storage array.

正解：B,D 解答を投票する

出題：12

Which port channel command is recommended for N1KV on Cisco UCS?

A. channel-group auto mode on sub-group manual

B. channel-group auto mode active

C. channel-group auto mode on sub-group cdp

D. channel-group auto mode on

E. channel-group auto mode on mac-pinning

正解：E 解答を投票する

出題：13

Which two statements about the FCIP Write Acceleration feature are true? (Choose two.)

A. The FCIP Write Acceleration feature can only be used with multilink port channels if they are constructed with port channel protocol.

B. The Write Acceleration feature does not have to be enabled on both sides of the FCIP link.

C. WAN throughput is maximized by minimizing the impact of WAN latency for write operations.

D. The Write Acceleration feature works by immediately returning the SCSI status on the initiator side of the FCIP link.

E. The Write Acceleration feature cannot be used across FSPF equal cost paths in FCIP deployments.

正解：C,E 解答を投票する

出題：14

Which option describes the default roles available to RBAC on Cisco Nexus switches?

A. admin, operator, network-admin, and network-operator

B. admin and read-only

C. admin, read-only, network-admin, and network-operator

D. vdc-admin, vdc-operator, network-admin, and network-operator

E. vdc-admin, vdc-operator, network-admin, and network-operator (for Nexus 7000) and network-admin and network-operator (for other Nexus switches)

正解：A 解答を投票する

350-080試験無料問題集「Cisco CCIE Data Center Written 認定」