352-001試験無料問題集（270題）「Cisco Certified Design Expert Qualification 認定」

出題：1

A BGP route reflector in the network is taking longer than expected to converge during large network changes. Troubleshooting shows that the router cannot handle all the TCP acknowledgement during route updates. Which action can be performed to tune the device performance?

A. increase the keepalive timers for each BGP neighbor

B. increase the size of the large buffers

C. increase the size of the hold queue

D. Decrease the size of the small buffers.

正解：C 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：2

Your company wants to deploy a new data center infrastructure Based on the requirements you have chosen VXLAN as encapsulation technology The customer is concerned about miss-configuration of Layer 2 devices and DC wide outages caused by Layer 2 loops What do you answer?

A. VPC+ could prevent L2 loop on access ports

B. Storm Control should be enabled on all ports

C. BPDU Guard should be enabled on all VTEP access ports

D. VXLAN offers native loop avoidance mechanism

正解：C 解答を投票する

出題：3

You are designing a traffic monitoring and analysis system for a customer. Which traffic monitoring technique would you recommend to place the least amount of burden on the network infrastructure?

A. NetFLow

B. SPAN monitor ports

C. IP NBAR

D. Passive taps

正解：D 解答を投票する

出題：4

Refer to the exhibit.

There are multiple trees in the Cisco FabricPath All switches in the Layer 2 fabric share the same view of each tree. Which two concepts describe how the multicast traffic is load-balanced across this topology? (Choose two )

A. A specific (S.G) traffic is not load-balanced

B. A specific (S.G) multicast traffic is load-balanced across all trees due to better link utilization efficiency.

C. The multicast traffic is generally load-balanced across all trees

D. Every leaf node assigns the specific (S.G) to the same tree.

E. All trees are utilized at the same level of the traffic rate

正解：B,E 解答を投票する

出題：5

Which description of the fundamental design differences between an IP-based network design and a SAN-based design is true?

A. An IP-based design has redundant connectivity In the fabric and high amounts of east-west traffic, whereas a SAN-based design uses zoning- based redundancy, which uses separate fabrics and has very little east-west traffic

B. An IP-based design has redundant connectivity in the fabric and very little east-west traffic, whereas a SAN-based design uses redundancy in the host, which uses separate fabrics and has high amounts of east-west traffic

C. An IP-based design has redundant connectivity in the fabric and high amounts of east-west traffic, whereas a SAN-based design uses redundancy from a dual-attached host which uses separate fabrics and has very little east-west traffic

D. An IP-based design has redundancy from the host and high amounts of east-west traffic, whereas a SAN-based design uses redundancy in the fabric and very little east-west traffic

正解：C 解答を投票する

出題：6

You are hired to design a solution to improve network availability for users on a campus network with routed access. Which two recommendations should you make in your design proposal? (Choose two)

A. standby route processors for SSO in the core routers

B. redundant power supplies in the access routers

C. replace copper links between devices with fiber links

D. standby route processors for SSO in the distribution routers

E. standby route processors for SSO in the access switches

正解：B,E 解答を投票する

出題：7

When network summaries are created for access networks in a network design, how does it change the behavior of the shortest Path First (spf) running in a backbone area?

A. There would be fewer partial SPFs.

B. There would be no change with the SPFs.

C. There would be fewer incremental SPFs.

D. There would be fewer full SPFs.

正解：A 解答を投票する

出題：8

A network engineering team is designing a lab network for a customer demonstration. The design engineer wants to show that the resiliency of the MPLS Traffic Engineering Fast Reroute solution has the same failover Tailback times as a traditional SONET/SDH network (around 50 msec). Which type of MPLS TE tunnel must be considered for this demonstration to address the link failure and node failure within the lab network?

A. next-hop tunnel

B. TE backup tunnel

C. FRR backup tunnel

D. next-next-hop tunnel

正解：D 解答を投票する

出題：9

In a routed access hierarchical campus design, the access-to-distribution Layer 2 uplink trunks are replaced with Layer 3 point-to-point routed links. Why is it recommended that VLANs are confined on a single access switch rather than span across multiple access switches?

A. to allow for better convergence time

B. to prevent the occurrence of Layer 2 loops

C. to prevent routing black holes

D. to allow for fault isolation

正解：C 解答を投票する

出題：10

You are designing an Out of Band Cisco Network Admission Control. Layer 3 Real-IP Gateway deployment for a customer Which VLAN must be trunked back to the Clean Access Server from the access switch?

A. management VLAN

B. authentication VLAN

C. user VLAN

D. untrusted VLAN

正解：A 解答を投票する

出題：11

What are two key design principles when using a hierarchical core-distribution-access network model? (Choose two )

A. The core layer controls access to resources for security

B. The core layer is designed first, followed by the distribution layer and then the access layer

C. A hierarchical network design model aids fault isolation

D. A hierarchical network design facilitates changes

E. The core layer provides server access in a small campus.

正解：C,D 解答を投票する

出題：12

Drag and drop the jitter definition and how to compensate for it from the left onto the right

正解：

出題：13

ACME corporation is deploying a new HR application that requires the network infrastructure to monitor and react to certain conditions in the network. Which feature should be used to meet this design requirement?

A. Cisco IOS Embedded Event Manager

B. IP SLA

C. SOAP

D. Reflexive ACLs

正解：A 解答を投票する

352-001試験無料問題集「Cisco Certified Design Expert Qualification 認定」