642-732試験無料問題集（195題）「Cisco Conducting Cisco Unified Wireless Site Survey (CUWSS) v2.0 認定」

出題：1

An engineer is preparing to conduct a site survey with AirMagnet. The engineer wants to capture all 802.11 traffic (not SSID specific) on the first walkthrough. Which survey mode should be used?

A. planning mode survey

B. active with Iperf for greenfield: SSID mode

C. active

D. passive

E. active with Iperf for greenfield: AP mode

正解：D 解答を投票する

出題：2

A customer is experiencing slower client data throughput than the data rate setting. Which two wireless characteristics are the primary contributing factors? (Choose two.)

A. Overlapping channels cause co-channel interference.

B. 802.11 acknowledges all packets, which halves throughput on the channel.

C. Clients that are farther from the access point connect at a slower data rate.

D. Lower data rates decrease overall throughput.

E. All clients on a given access point share the bandwidth of the channel.

F. Broadcast and multicast are sent at the lowest associated data rate.

正解：B,E 解答を投票する

出題：3

Refer to the exhibit.

After performing a Layer 1 survey using Cisco Spectrum Expert, what is the result indicated by the visual screen?

A. Normal 802.11g activity

B. Bluetooth device interference

C. Microwave oven interference

D. Normal 802.11b activity

E. Video camera interference

正解：B 解答を投票する

出題：4

A customer is preparing for a site survey. The building is in the middle of construction and not all walls are constructed. What is the most practical way to do this site survey?

A. Obtain architect drawings of the facilities with dimensions and floor height.

B. Add 2.5 APs on every floor to compensate for future RF blocks.

C. Use Cisco WCS planning mode to conduct the site survey and file a proposal to the customer.

D. Conduct a passive survey of the facility using temporary APs.

正解：C 解答を投票する

出題：5

Mesh APs are commonly mounted alongside a pole, meaning they are both vertically aligned and the pole could partially block the mesh AP RF signal. What is the maximum degree angle to allow for blockage of the antenna field of view?

A. 5 degrees

B. 15 degrees

C. 2 degrees

D. 10 degrees

正解：A 解答を投票する

出題：6

Which two options describes the vertical RF coverage pattern of an antenna? (Choose two.)

A. E-plane

B. View from the side

C. H-plane

D. View from above

E. Azimuth

正解：A,B 解答を投票する

出題：7

Which two statements best describe the Fresnel zone related to an outdoor RF point-topoint link? (Choose two.)

A. blocks no more than 20 percent

B. comprises multiple zones of which the outside zone is the most important to keep clear

C. comprises multiple zones of which the first inside zone is the most important to keep clear

D. blocks no more than 40 percent

E. comprises a single zone to keep clear

F. blocks no more than 60 percent

正解：C,D 解答を投票する

出題：8

Which three reasons describe the importance of assessing existing wired infrastructure? (Choose three.)

A. determine CAPWAP support

B. determine quality of service

C. determine port bandwidth

D. determine UPS requirement

E. determine cable length

F. determine PoE requirement

G. determine LWAPP support

正解：C,E,F 解答を投票する

出題：9

After having the kick-off meeting for a new site survey project with your customer, which three factors need to be considered prior to beginning a WLAN site survey? (Choose three.)

A. Will any additional regulatory or safety training be required to complete the site survey?

B. Is access available to all areas of the customer facility where the WLAN is planned to be deployed?

C. Is access available to customer employees so that initial interviews can be performed?

D. Will an additional trip to the facility to perform the initial walkthrough be required?

E. How much time should be allocated to survey the locations for the controllers?

F. Which types of controllers and switches will be required to fully conduct the site survey in all areas of the customer facility?

正解：A,B,D 解答を投票する

出題：10

An engineer is conducting a VoWLAN survey for voice clients with a max power of 40 mW. What power level should the engineer set the AP to during the survey?

A. 40 mW

B. 30 mW

C. 20 mW

D. 5 mW

E. 10 mW

正解：C 解答を投票する

出題：11

Refer to the exhibit.

Which type of cable connector is displayed that is used to connect antennas to transmitters?

A. SMA

B. SMB

C. RP-TNC

D. MMCX

E. N

正解：E 解答を投票する

出題：12

A customer has requested site surveys for data, voice, video, and location services for their location. The customer will be using RFID tags extensively. Which type of site survey should be conducted?

A. bridging

B. voice

C. multi-survey

D. video

E. data

F. location-based services

正解：F 解答を投票する

642-732試験無料問題集「Cisco Conducting Cisco Unified Wireless Site Survey (CUWSS) v2.0 認定」