800-150試験無料問題集（102題）「Cisco Supporting Cisco Devices for Field Technicians 認定」

出題：1

Which action must be taken when editing a captured configuration of an old device for reuse in a replacement device?

A. Keep all access-list commands intact.

B. Retain all username entries.

C. Remove all configurations under line vty 0 4.

D. Add the enable password cisco command.

正解：B 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：2

Which cable type should be used when installing replacement hardware and connecting two devices of the same type, like two DTEs or two DCEs?

A. USB Type A to Type B cable

B. RJ-45 Ethernet straight-through patch cable

C. RJ-45 Ethernet crossover patch cable

D. Rolled RJ-45 to RJ-45 console cable

正解：C 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：3

Which layer of the OSI model provides error detection and defines how access to the media is controlled?

A. Network layer

B. Data link layer

C. Presentation layer

D. Physical layer

正解：B 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：4

Which two components are accessed by removing the chassis cover on Cisco Catalyst 8000 Series Edge platforms? (Choose two.)

A. Transceivers

B. SSDs

C. DIMMs

D. Fan trays

E. Network Interface Modules

正解：B,C 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：5

Which step must be performed immediately after disconnecting the network cable when replacing an SFP transceiver module?

A. Reinstall dust plugs in the optical bores.

B. Disconnect the SFP latch.

C. Install the replacement SFP module.

D. Observe the port status LED.

正解：A 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：6

Drag and drop the Cisco collaboration endpoints from the left onto the corresponding descriptions on the right.

正解：

800-150試験無料問題集「Cisco Supporting Cisco Devices for Field Technicians 認定」