1Y0-740試験無料問題集「Citrix WANScaler 4.2: Administration 認定」

Which two statements are true regarding protocol acceleration? (Choose two.)

Scenario: A System Administrator is attempting to configure a QoS solution for a routine file transfer that is critical to the organization. The file is transferred using FTP and it is important that no other traffic suppresses the transfer to less than 20% of the bandwidth limit. In addition, all queues must be named appropriately. Which three steps should the administrator take to meet the requirements of this scenario? (Choose three.)

正解:D,E,F 解答を投票する
Which two techniques are used to accelerate and optimize CIFS traffic across high latency links in a WANScaler appliance implementation? (Choose two.)

An administrator needs to configure the IP address of the apA accelerated interface of a WANScaler appliance from the serial interface. Which command should the administrator use to specify the IP address?

Which three of the listed combinations are valid? (Choose three.)

正解:C,D,E 解答を投票する
Which two pieces of information must an administrator specify when configuring RADIUS authentication on a WANScaler appliance? (Choose two.)

The WANScaler Common Internet File System (CIFS) acceleration is enabled but the connection still shows up as unaccelerated. What are two steps that an administrator can take to troubleshoot this issue? (Choose two.)

An administrator is instructed to allow multiple routers to share a WANScaler appliance by forwarding output packets to the Ethernet address of the corresponding incoming packet.
According to best practices, which option for deciding where to send the packet will be desirable for this implementation?

In an environment where two sites are connected by a point-to-point circuit and partial bandwidth is enabled, which acceleration mode will be supported?

Scenario: An administrator for a WANScaler environment has an existing Viewer type user account (VIEW_ALL) and a default Admin type account (Admin_ALL) to access the WANScaler appliances. A second administrator needs access to the WANScaler appliances, specifically the System Tools: Restart System and Monitoring: Usage Graph pages.
At a minimum, what should the administrator do so that the other administrator can access these pages?