D-PDD-DY-23試験無料問題集（165題）「EMC Dell PowerProtect Data Domain Deploy 2023 認定」

出題：1

What rule must be followed during an upgrade procedure with the FS25 expansion shelf?

A. FS25 shelf is cabled on a separate private chain

B. FS25 shelf must be on the same chain with DS60

C. If ES40 SAS shelves are on the same chain as an FS25, the maximum number of shelves on that chain is five

D. For high performance, the connections from a controller to FS25 shelves must be over FC cables

正解：A 解答を投票する

出題：2

A systems administrator wants to change encryption.
Which user role is needed to log in, and what command must be run to enable the security policy?

A. sysadmin user and run authentication policy set security-officer enabled

B. security officer user and run authentication policy set security-officer enabled

C. sysadmin user and run authorization policy set security-officer enabled

D. security officer user and run authorization policy set security-officer enabled

正解：D 解答を投票する

出題：3

Which are two attributes of PowerProtect High Availability? ( Select 2 )

A. supported only on DD9900 systems

B. PowerPotect DD nodes should have dual heads

C. Power Protect DD nodes are configured in active active mode

D. single set of shared storage is used

正解：B,C 解答を投票する

出題：4

An engineer is attempting to add an ES40 shelf to a PowerProtect DD9400. The system currently has one DS60 and four ES40 shelves on the same chain. The system does not recognize the additional shelf.
Why has this occurred?

A. ES40 and DS60 shelves must be placed on separate chains

B. The system capacity license is insufficient

C. An active tier license must be added for additional storage

D. The maximum number of shelves on the chain is exceeded

正解：D 解答を投票する

出題：5

Which protocol is used for communications between a PowerProtect DD appliance and cloud tier to Dell EMC ECS?

A. SSL

B. HTTPS

C. FTP

D. SSH

正解：B 解答を投票する

出題：6

An organization uses tape libraries in their current backup infrastructure. They have purchased a PowerProtect DD system and plan to use VTL to move from physical tape.
What is a consideration when configuring the tape size?

A. Target multiple drives to write single stream

B. Use multiple drives to write multiple streams

C. Set retention periods for as long as possible

D. Use larger tapes for multiple smaller datasets

正解：B 解答を投票する

出題：7

With DSP enabled on a PowerProtect DD appliance, which functions are performed on the backup host?

A. Segmenting fingerprinting, and sending the fingerprints

B. Sending the data, segmenting, and compressing

C. Recording references to previous data and segmenting

D. Compressing segmenting, and fingerprinting

正解：A 解答を投票する

出題：8

When using CIFS from a PowerProtect DD system, what should be changed on a Windows machine?

A. CIFSTimeout to 3600 seconds

B. SMBTimeout to 7200 seconds

C. SESSTIMEOUT to 3600 seconds

D. SESSTIMEOUT to 7200 seconds

正解：C 解答を投票する

出題：9

Where can the serial number on a PowerProtect DD appliance be found?

A. Label attached to the bezel

B. PSNT tag at the rear of the system

C. Label on the top of the chassis

D. Right side of the chassis

正解：B 解答を投票する

出題：10

A backup administrator is tasked with monitoring PowerProtect DD capacity metrics. The administrator is backing up 4 TB of data daily with a reduction rate at 5x. After data reduction, subsequent full backups compress down to 200 GB. The initial backup requires 800 GB with a 10 percent increase in the data each day.
Incremental backups are 400 GB. After data reduction, each incremental backup is 40 GB.
What is the weekly burn rate (GB) after four daily incremental backups and one weekly backup?

A. 320

B. 360

C. 440

D. 400

正解：B 解答を投票する

D-PDD-DY-23試験無料問題集「EMC Dell PowerProtect Data Domain Deploy 2023 認定」