E20-807試験無料問題集「EMC Expert - VMAX All Flash and VMAX3 認定」

Performance analysis on VMAX3 FE ports have shown that a large number of QFULL responses were returned to their best performing hosts. However, other hosts suffered from high response times.
What needs to be configured in order to lower the high response times?

Which RDF mode is active during the Non-Disruptive Migration Cutover Ready state?

With a response time of 2 ms, the utilization is at 50%. Based on Little's Law, what is the new service time if the utilization increases to 80%?

While analyzing performance of a VMAX3 array, the following details are observed?
* High host response time
* Low FE response time
* High host CPU utilization
What should be investigated further?

FAST.X needs to be configured on a VMAX3 array to access LUNs on an XtremIO X-Brick. In addition, existing data on the LUNs has to be preserved and made available for host access.
How can this be accomplished?

Which special considerations are required for non-ALUA arrays and FAST.X?

What is the correct sequence of steps when the Non-Disruptive Migration create operation is run?
正解:

Explanation

References:
On a VMAX3 array, which SYMACL security concept controls a list of hosts with unique IDs?