F5CAB5試験無料問題集「F5 BIG-IP Administration Support and Troubleshooting 認定」

Clients report that they cannot reach the virtual server vs-production on port 80, but are able to ping the virtual server address. The configuration is shown below:
Plaintext
ltm virtual vs-production {
destination 10.99.20.50:http
ip-protocol tcp
mask 255.255.255.255
profiles {
http {}
tcp {}
}
source 192.168.0.0/16
translate-address enabled
translate-port enabled
vlans {
external
}
vlans-enabled
}
What is the cause?

解説: (GoShiken メンバーにのみ表示されます)
A BIG-IP device sends out the following SNMP trap:
big-ipo.f5.com - bigipExternalLinkChange Link: 1.0 is DOWN.
Where in the BIG-IP Configuration utility should the BIG-IP Administrator verify the current status of Link 1.0?

解説: (GoShiken メンバーにのみ表示されます)
Which tmsh command shows virtual server status?

What information is required for a BIG-IP Administrator to open an F5 Support ticket?

解説: (GoShiken メンバーにのみ表示されます)
A BIG-IP Administrator disabled a virtual server with a pool that has a working health monitor.
How does the status icon look for this virtual server?

解説: (GoShiken メンバーにのみ表示されます)
Refer to the exhibit.

A BIG-IP Administrator configured a virtual server with a pool of 3 members and selected the Round Robin load balancing method to evenly distribute traffic across the pool members. During initial testing, traffic was not evenly distributed and the pool member 172.16.20.3 received more traffic than the other pool members.
Refer to the exhibit and the virtual server configuration provided below:
Plaintext
ltm virtual http.vs {
destination 10.10.1.100:http
ip-protocol tcp
mask 255.255.255.255
persist {
source_addr { default yes }
}
pool http.pool
profiles {
tcp{}
}
serverssl-use-sni disabled
source 0.0.0.0/0
source-address-translation {
type automap
}
translate-address enabled
}
What is the most likely cause of this behavior?

解説: (GoShiken メンバーにのみ表示されます)
Due to a change in application requirements, a BIG-IP Administrator needs to modify the configuration of a Virtual Server to include a Fallback Persistence Profile. Which persistence profile type should the BIG-IP Administrator use for this purpose?

解説: (GoShiken メンバーにのみ表示されます)
The BIG-IP appliance fails to boot. The BIG-IP Administrator needs to run the End User Diagnostics (EUD) utility to collect data to send to F5 Support. Where can the BIG-IP Administrator access this utility?

解説: (GoShiken メンバーにのみ表示されます)
Which process is most likely responsible for high traffic processing CPU usage?

解説: (GoShiken メンバーにのみ表示されます)