FCSS_SDW_AR-7.4試験無料問題集（75題）「Fortinet FCSS

出題：1

Which statement describes FortiGate behavior when you reference a zone in a static route?

A. FortiGate routes the traffic through the best performing member of the zone.

B. FortiGate installs a static route for each member in the zone.

C. FoftiGate installs ECMP static routes for the first two members of the zone.

D. FortiGate ignores the static routes defined through members referenced in the zone.

正解：B 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：2

Refer to the exhibit. You want to configure SD-WAN on a network as shown in the exhibit. The network contains many FortiGate devices. Some are used as NGFW, and some are installed with extensions such as FortiSwitch, FortiAP or FortiExtender. What should you consider when planning your deployment?

A. You must use FortiManager to manage your SD-WAN topology.

B. You must build multiple SD-WAN topologies. Each topology must contain only one type of extension.

C. You can build an SD-WAN topology that includes all devices. The hubs must be devices without extensions.

D. You can build an SD-WAN topology that includes all devices. The hubs can be FortiGate devices with FortiExtender.

正解：D 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：3

Refer to the exhibit. Which statement best describe the role of the ADVPN device in handling traffic?

A. This is a spoke that has received a direct shortcut query from a remote spoke.

B. This is a spoke that has received a shortcut query from a remote hub.

C. This is a hub, and two spokes, 192.2.0.1and 10.0.3.101, establish a shortcut.

D. This is a hub that has received a shortcut query from a spoke and has forwarded it to another spoke.

正解：D 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：4

Refer to the exhibit. Two hub-and-spoke groups are connected through redundant site-to-site IPsec VPNs between Hub 1 and Hub 2.
Which two configuration settings are required for the spoke A1 to establish an ADVPN shortcut with the spoke B2? (Choose two.)

A. On hubs, auto-discovery-sender must be enabled on the IPsec VPNs to spokes.

B. On hubs, auto-discovery-receiver must be enabled on the IPsec VPNs to spokes.

C. On hubs, auto-discovery-forwarder must be enabled on the IPsec VPNs to spokes.

D. On hubs, auto-discovery-forwarder must be enabled on the IPsec VPNs to hubs.

正解：A,D 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：5

Refer to the exhibits.
You use FortiManager to configure SD-WAN on three branch devices.

When you install the device settings, FortiManager prompts you with the error "Copy Failed" for the device branch1_fgt. When you click the log button, FortiManager displays the message shown in the exhibit.
There are two different ways to resolve this issue. Based on the exhibits, which methods could you use? (Choose two.)

A. Specify the gateway of the SD-WAN member port1 with an IP address or use the default value.

B. Review the per-device mapping configuration for metadata variables

C. Update the management IP address of branch1_fgt.

D. Do not define installation targets for SD-WAN members.

正解：A,B 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：6

Which three factors about SLA targets and SD-WAN rules should you consider when configuring SD-WAN rules? (Choose three.)

A. SD-WAN rules can use SLA targets to check whether the preferred members meet the SLA requirements.

B. Member metrics are measured only if a rule uses the SLA target.

C. SLA targets are used only by SD-WAN rules that are configured with a Lowest Cost (SLA) strategy.

D. When configuring an SD-WAN rule, you can select multiple SLA targets from different performance SLAs.

E. When configuring an SD-WAN rule, you can select multiple SLA targets if they are from the same performance SLA.

正解：A,C,D 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：7

An administrator is configuring SD-WAN to load balance their network traffic. Which two things should they consider when setting up SD-WAN? (Choose two.)

A. SD-WAN load balancing is possible only using the best quality and lowest cost (SLA) strategies.

B. Only the manual and best-quality strategies allow SD-WAN load balancing.

C. You can select the outbandwidth hash mode with all strategies that allow load balancing.

D. When applicable, FortiGate load balances the traffic through all members that meet the SLA target.

正解：C,D 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：8

Refer to the exhibit. What conclusions can you draw about the traffic received by FortiGate originating from the source LAN device 10.0.1.133 and destined for the company's SMTP mail server at 10.66.0.125?

A. FortiGate steers the traffic from the LAN device 10.0.1.133 to the company SMTP mail server
10.66.0.125 through the SD-WAN member ID 4.

B. FortiGate steers the traffic from the LAN device 10.0.1.133 to the company SMTP mail server
10.66 0.125 through port3.

C. FortiGate steers the traffic from the LAN device 10.0.1.133 to the SMTP mail server 10.66.0.125 through the SD-WAN member ID 1 or 2.

D. ForliGate steers the traffic from the LAN device 10.0.1.133 to the company SMTP mail server
10.66.0.125 through port2.

正解：C 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

FCSS_SDW_AR-7.4試験無料問題集「Fortinet FCSS - SD-WAN 7.4 Architect 認定」