NSE5_FAZ-7.0試験無料問題集（116題）「Fortinet NSE 5

出題：1

Which statement is true when you are upgrading the firmware on an HA cluster made up of two FortiAnalyzer devices?

A. Both FortiAnalyzer devices will be upgraded at the same time.

B. You can perform the firmware upgrade using only a console connection.

C. You can enable uninterruptible-upgrade so that the normal FortiAnalyzer operations are not interrupted while the cluster firmware upgrades.

D. First, upgrade the secondary device, and then upgrade the primary device.

正解：D 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：2

In FortiAnalyzer's FormView, source and destination IP addresses from FortiGate devices are not resolving to a hostname. How can you resolve the source and destination IPs, without introducing any additional performance impact to FortiAnalyzer?

A. Configure local DNS servers on FortiAnalyzer

B. Configure # set resolve-ip enable in the system FortiView settings

C. Resolve IPs on a per-ADOM basis to reduce delay on FortiView while IPs resolve

D. Resolve IPs on FortiGate

正解：D 解答を投票する

出題：3

What statements are true regarding the "store and upload" log transfer option between FortiAnalyzer and FortiGate? (Choose three.)

A. Only FortiGate models with hard disks can send logs to FortiAnalyzer using the store and upload option.

B. All FortiGates can send logs to FortiAnalyzer using the store and upload option.

C. Both secure communications methods (SSL and IPsec) allow the store and upload option.

D. Disk logging is enabled by default on the FortiGate.

E. Disk logging is enabled on the FortiGate through the CLI only.

正解：A,C,E 解答を投票する

出題：4

You crested a playbook on FortiAnalyzer that uses a FortiOS connector
When configuring the FortiGate side, which type of trigger must be used so that the actions in an automation stitch are available in the FortiOS connector?

A. FortiOS Event Log

B. Incoming webhook

C. Fabric Connector event

D. FortiAnalyzer Event Handler

正解：B 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：5

An administrator fortinet, is able to view logs and perform device management tasks, such as adding and removing registered devices. However, administrator fortinet is not able to create a mall server that can be used to send email.
What could be the problem?

A. ADOM mode is configured with Advanced mode.

B. Fortinet is assigned the Restricted_ User administrator profile.

C. Fortinet is assigned the Standard_ User administrator profile.

D. A trusted host is configured.

正解：C 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：6

Which two statements express the advantages of grouping similar reports? (Choose two.)

A. Improve report completion time.

B. Conserve disk space on FortiAnalyzer by grouping multiple similar reports.

C. Provides a better summary of reports.

D. Reduce the number of hcache tables and improve auto-hcache completion time.

正解：A,D 解答を投票する

出題：7

Which statements are correct regarding FortiAnalyzer reports? (Choose two)

A. FortiAnalyzer includes pre-defined reports only.

B. FortiAnalyzer provides the ability to create custom reports.

C. FortiAnalyzer allows reporting for FortiGate devices only.

D. FortiAnalyzer glows you to schedule reports to run.

正解：B,D 解答を投票する

出題：8

Refer to the exhibit.

What does the data point at 14:55 tell you?

A. Raw logs are reaching FortiAnalyzer faster than they can be indexed

B. The received rate is almost at its maximum for this device

C. Logs are being dropped

D. The sqlplugind daemon is behind in log indexing by two logs

正解：A 解答を投票する

出題：9

An administrator has configured the following settings:
config system fortiview settings
set resolve-ip enable
end
What is the significance of executing this command?

A. It resolves the destination IP address to a hostname in FortiView on FortiAnalyzer.

B. It resolves the source and destination IP addresses to a hostname in FortiView on FortiAnalyzer.

C. Use this command only if the source IP addresses are not resolved on FortiGate.

D. You must configure local DNS servers on FortiGate for this command to resolve IP addresses on Forti Analyzer.

正解：A 解答を投票する

出題：10

What statements are true regarding FortiAnalyzer 's treatment of high availability (HA) dusters? (Choose two)

A. FortiAnalyzer receives bgs only from the primary device in the cluster.

B. FortiAnalyzer distinguishes different devices by their serial number.

C. FortiAnalyzer receives logs from d devices in a duster.

D. FortiAnalyzer only needs to know (he serial number of the primary device in the cluster-it automaticaly discovers the other devices.

正解：B,C 解答を投票する

NSE5_FAZ-7.0試験無料問題集「Fortinet NSE 5 - FortiAnalyzer 7.0 認定」