GB0-342-ENU試験無料問題集「H3CSE-WLAN 認定」

ページ: 1 / 17
トータル 340 問
完全版を入手する
What is true about the medical software architecture in the medical industry: (not sure)

When the diversity antenna interface of the AP is not used, or the power divider port is not used in the distributed system, in this case, it needs to be screwed to the interface with ______ to prevent the radio frequency interference from affecting the system.

Methods to Avoid Signal Interference in Comprehensive Office Areas

正解：A,B,C,D 解答を投票する
Which of the following are ideas for WLAN optimization

正解：A,B,C 解答を投票する
The highest rate that can be negotiated with an 802.11n wireless network card using a 20MHz channel bandwidth for an 802.11n-enabled AP is _______

When logging into the FATAP management interface through the WEB interface, what is the correct default username and password?

Power management is an important attribute of wireless terminals, it will choose a balance between power consumption and adapter performance, which will affect the user's network experience.
For example, usually the power management properties of an Inter wireless network card are set to maximize the performance of the network card.

What are the commonly used troubleshooting commands for WLAN network failures?

正解：A,B,C,D 解答を投票する
Run the command " display wlan client mac--address XXXX--XXXX-XXXX " to view the detailed running status of the wireless client.
Which numbers reflect the received signal strength and quality at the client?

H3CN to N cable is used to connect outdoor AP with N-type connector and outdoor antenna or used to extend feeder with N-type double female connector. There are three sizes of 1.83m, 4.5m and _______m to choose from. Purchasing this type of cable saves the trouble of field machining an N-type adapter cable

If a wireless local area network only contains STA, this network structure has a special name in the 802.11 network, this name is _____

The so-called modulation is to change the relevant properties of the carrier according to the information to be sent, so that the information is encoded on the carrier. The properties of the basic carrier that can be modulated are:

正解：A,B,C 解答を投票する
Generally speaking, if the modulation method used is more complicated, the transmission rate obtained is ______, and the coverage of the wireless signal is ______.

During the Layer 2 registration of the Fit AP, it is found that the AP is in the Idle state on the AC. The possible reasons are as follows.

正解：A,B,D,E 解答を投票する
The wireless network authentication method for user authorization authentication by linking with the radius server is. (only for advanced exam)

The wireless AP has FAT and FIT modes, in which the default AP address in FAT mode is ___ (single choice)
Default username: admin Default password: h3capadmin

Which of the following is true for the AP installation specification description:

正解：A,B,C,D 解答を投票する
What are the troubleshooting methods for the wireless network? (The general title means this)

正解：A,B,C 解答を投票する
Using the wireless bridge function can realize one-to-one or one-to-many wireless connection between Fat APs. In order to ensure the effective bandwidth of each link, the number of connected APs should not be too many. The above statement is _____.

The wireless controller models with a maximum number of managed APs of 6144 are

ページ: 1 / 17
トータル 340 問