HP0-Y46試験無料問題集「HP Implementing HP Network Technologies 認定」
A network administrator is building two IRF domains:
-One domain for the two distribution layer switches -One domain for the access layer switches
Each access layer switch should have a connection to each distribution layer switch. In this design, how many access switches can the administrator have in the access layer IRF domain before spanning tree is required to remove loops between the two IRF domains?
-One domain for the two distribution layer switches -One domain for the access layer switches
Each access layer switch should have a connection to each distribution layer switch. In this design, how many access switches can the administrator have in the access layer IRF domain before spanning tree is required to remove loops between the two IRF domains?
正解：C
解答を投票する
A network administrator enables debug to troubleshoot an OSPF adjacency on an HP Comware switch. The network administrator then disables and then re-enables an interface connected to another switch running OSPF. After waiting for a few minutes, no output displays on the console.
Which action must the network administrator take to resolve this problem?
Which action must the network administrator take to resolve this problem?
正解：D
解答を投票する
Refer to the HP Provision and HP Comware configurations.
An aggregated link has been defined between the Provision A1 and A2 switches, as well as between the Comware g1/0/1 and g1/0/2 switches. 1 and 2 is not being passed between the switches. However, during the network administrator's tests, traffic for VLAN. What is the cause of this problem?
An aggregated link has been defined between the Provision A1 and A2 switches, as well as between the Comware g1/0/1 and g1/0/2 switches. 1 and 2 is not being passed between the switches. However, during the network administrator's tests, traffic for VLAN. What is the cause of this problem?
正解：A
解答を投票する
A network administrator receives a new HP Provision switch and notices that the software version running on the switch is older than what is currently used in the network. The network administrator copies an updated version of the operating system from the new switch's USB port to the secondary flash location. The network administrator then executes the following command:
ProVision # boot system flash secondary
The switch reboots using the new operating system. However, when the network administrator turns off the switch and turns it back on, the switch boots from the old operating system. Which solution should the network administrator use to fix the problem?
ProVision # boot system flash secondary
The switch reboots using the new operating system. However, when the network administrator turns off the switch and turns it back on, the switch boots from the old operating system. Which solution should the network administrator use to fix the problem?
正解：C
解答を投票する
A network administrator is building two IRF domains:
-One domain for the two distribution layer switches -One domain for the access layer switches
Each access layer switch should have a connection to each distribution layer switch. In this
design, how many access switches can the administrator have in the access layer IRF domain before spanning tree is required to remove loops between the two IRF domains?
-One domain for the two distribution layer switches -One domain for the access layer switches
Each access layer switch should have a connection to each distribution layer switch. In this
design, how many access switches can the administrator have in the access layer IRF domain before spanning tree is required to remove loops between the two IRF domains?
正解：C
解答を投票する
