HPE7-A04試験無料問題集（100題）「HP Aruba Certified Data Center Architect 認定」

出題：1

In which situation do you need to select switches with a back-front (BF) airflow?

A. The switches are ToR switches which will have the port side facing the same way as server ports

B. The switches are middle of the rack switches with their ports facing the cold aisle

C. The switches are ToR switches which will have the port side facing the opposite way as server ports

D. The switches are core switches in a dedicated rack with their ports facing the cold aisle

正解：A 解答を投票する

出題：2

What is true about the assumption documents

A. Assumptions are only needed if the customer asks for it

B. Assumptions vary based on the project

C. Must never be included in the solution proposal

D. Assumptions are so essentials that they need to always be included with every solution

正解：B 解答を投票する

出題：3

Two VMs on the same ESXi host are assigned to an isolated VLAN 2001 (primary VLAN 1001). The host connects to an HPE Aruba CX 10000 switch on an access port. The switch supports the same PVLAN settings. VM 1 sends traffic to VM 2. Which policy or policies does the switch apply (assuming that they exist)?

A. Egress policy on VLAN 1001

B. No policies because the traffic remains local to the ESXi host

C. Ingress policy on VLAN 1001

D. Ingress and egress policy on VLAN 1001

正解：A 解答を投票する

出題：4

You want to configure your border leaf switches to leak routes between an overlay VRF named "dc1" and a VRF named "campus," which connects to the campus core. You also want to leak routes between an overlay VRF named "dc2" and the campus VRF. "dc1" should not be able to communicate with "dc2." Which is a valid design for the VRFs' IPv4 route-targets?

A. vrf dc1, import = 1:1, export = 1:1; vrf dc2, import = 1:2, export = 1:2; vrf campus, import = 1:1, 1:2, 1:
99, export = 1:99

B. vrf dc1, import = 1:99, export = 1:1; vrf dc2, import = 1:99, export = 1:2; vrf campus, import = 1:1, 1:2 export = 1:99

C. vrf dc1, import = 1:1, export = 1:1; vrf dc2, import = 1:1, export = 1:1; vrf campus, import = 1:1, export
= 1:99

D. vrf dc1, import = 1:1, export = 1:99; vrf dc2, import = 1:2, export = 1:99; vrf campus, import = 1:99, export = 1:1, 1:2

正解：B 解答を投票する

出題：5

In one of the spine and leaf designs, VMware vSphere is used including VMware NSX. OSPF is used for routing protocol across the spine and leaf topology. What do you need to consider in this design? (Select three)

A. Using an IP MTU of 9198 on leaf-to-spine links

B. Adding an anycast loopback interface on each VSX pair

C. Enabling OSPF in passive interface mode on the NSX transport VLAN

D. Using a L2 MTU of 9198 on leaf-to-spine links

正解：A,C,D 解答を投票する

出題：6

Which CX switch model supports ERPS/VSX DCI?

A. 2930F

B. 8100

C. 8325

D. 5130

正解：C 解答を投票する

出題：7

What is true about rollback plan for migration phases? (Select two)

A. Archive Last known good configuration (state)

B. Staff members can't be included in rollback dependency

C. Determine maximum time for rollback

D. Don't give a timeframe for the rollback as this might affect customer confidence in your solution

正解：A,C 解答を投票する

出題：8

What Fiber Optic standard supports up to 400 Gbps

A. No standard supports that bandwidth

B. QSFP+

C. QSFP28

D. QSFP-DD

正解：D 解答を投票する

出題：9

What delivery documents are included in the post-installation handover?

A. Devices Quick Specs

B. Archived configurations

C. Inventory

D. Devices Datasheets

E. Cost of the project

正解：B,C 解答を投票する

出題：10

Which management solution for HPE Aruba Networking CX switches integrates tightly with VMware?

A. HPE Aruba Networking Fabric Composer (AFC)

B. HPE Aruba Networking NetEdit

C. HPE Aruba Networking ClearPass Policy Manager

D. HPE Aruba Networking Central

正解：A 解答を投票する

HPE7-A04試験無料問題集「HP Aruba Certified Data Center Architect 認定」