H12-323_V2.0試験無料問題集「Huawei HCIP-WLAN V2.0 認定」

ページ: 1 / 48
トータル 713 問
完全版を入手する
In the network design of WLAN project in warehousing and logistics industry, which of the following descriptions about the channel planning considerations is correct? (Multiple choice)

正解：A,B,C 解答を投票する
During the WLAN planning process, why is a site survey necessary?

An engineer inspected the customer's live network and found that the VRPP hot backup failed to be established. He queried relevant information through the following command line, and the following information was displayed.

According to the echo information, which of the following is the main reason for the failure of hot standby establishment?

An engineer configures the dynamic load balancing function on a Huawei wireless controller. The relevant command lines are as follows. Which options are correct regarding the description of the configuration command lines? (Multiple choice)

正解：A,C,D 解答を投票する
On WLAN devices, STA blacklist and whitelist can be referenced in AP system template or VAP template, but STA blacklist and STA whitelist cannot be configured at the same time for a VAP template or AP system template. For example, if STA whitelist is configured in a VAP template, if STA blacklist is configured in this VAP template, the configuration will be refreshed to STA blacklist configuration, without STA whitelist configuration.

In a WLAN network, adjacent channels 36 and 40 with a bandwidth of 20 MHZ are bundled into a channel with a bandwidth of 40 MHZ. Which of the following descriptions of this channel bundling scenario are correct? (Multiple choice)

Perform a roaming test through the CloudCampus app. After the test is completed, the roaming record is as shown in the figure below. Which options are correct for describing this roaming?
(Multiple choice)

正解：A,B,C 解答を投票する
Backup of Portal authentication information is not supported in dual-link hot standby scenarios. If Portal authentication is configured, wireless users using Portal authentication need to re-enter their username and password after the active/standby WAC switchover.

When factors such as interference and line loss are not considered, the calculation formula for the received signal strength is: final signal field strength - AP transmit power + MINO gain + () - ()
- obstacle signal attenuation.
正解：
Antenna gain | Transmission distance attenuation value
In Portal authentication scenarios, the WAC is used as the access device, and Portal users fail to be authenticated. Which of the following are the possible causes of this problem? (Choose all that apply.)

正解：A,B,C 解答を投票する
解説: (GoShiken メンバーにのみ表示されます)
Under the premise of the same material thickness, which of the following obstacles has the greatest attenuation for 5GHz signals?

When using CloudCampus APP for project delivery, which of the following tools does not include the one that users need to log in to the WLAM Planner project with their account?

In existing network applications, there is a type of terminal that has poor roaming initiative, which is mainly manifested in that it always "sticks" to the AP it initially associated with. Even if the terminal moves far away from the currently associated AP, the signal is weak, and the rate is low, this type of terminal still cannot roam to other neighboring APs with better signals. This type of terminal is called a sticky terminal. Which of the following is a roaming optimization solution for sticky users?

The VRRP hot backup of Huawei wireless controller only supports VRRP master-slave backup mode and does not support VRRP load sharing mode.

In healthcare scenarios, areas such as wards and consultation rooms typically consist of multiple isolated small rooms. Therefore, wall plate APs or agile distributed RUs can be deployed in each small room to provide wireless coverage.

解説: (GoShiken メンバーにのみ表示されます)
ページ: 1 / 48
トータル 713 問