H12-831-ENU試験無料問題集「Huawei HCIP-Datacom 認定」

Which of the following statements about OSPF's Router LSA and Network LSA is wrong? (Multiple choice)

The IS-IS neighbor relationship between R3 and R1 is not established. According to the information in this figure, what is the possible reason?

BGP routing policy can control the publishing and receiving of routes.

By default, LDP adjacencies will trigger the establishment of LSP based on IP routing of 32-bit addresses.

As shown below:

In an MPLS network, SRs running the DP protocol exchange LDP messages to implement functions such as neighbor discovery, session establishment and maintenance, and label management. To ensure the reliability of message delivery, all LDP messages are sent and received based on TCP connections.

Which of the following statements about the endpoint security management features of Agile Controller are correct? (Multiple choice)

正解:A,B,C,D 解答を投票する
As shown in the figure, OSPF is enabled on all interfaces of the router. The ip address marked in the figure is the IP address of the loopback0 interface. The Loopback0 of R1, R2, and R3 is advertised in area 1, and the Loopback0 of R4 is advertised in area 0, Loopback0 of R5 announces which of the following functional addresses in area 2 can ping each other?

As shown in the figure, the router runs OSPF, and Area 2 is a completely stubby area. Please match the LSA type and area ID contained in each area.

正解:
OSFFv2 is an IGP running on an IPv4 network, and OSPFV3 is an IGP running on an IPv6 network. Compared with OSPFv2, OSPFv3 has a similar LSA type, but has slightly different functions. Which of the following is not included in the LSA type of OSPFv3?

When performing software and configuration backups, which of the following is correct?

Ethernet is a network that supports broadcasting. Once there is a loop in the network, this simple factory broadcasting mechanism will cause catastrophic consequences. Which of the following phenomena may be caused by loops? (Multiple choice)

正解:A,B,C,D 解答を投票する
R1, R2, R3, and R4 belong to OSPF area 0, and the cost of the link is shown in the figure.

Loopback0 of R1, R2, R3, and R4 is advertised into OSPF. R1, R2, R3, and R4 use Loopback0 as the connection interface to establish an IBGP peer relationship. R1, R2, and R3 are clients of R4. The directly connected network segment 172.20.1.4/32 of R4 is advertised into BGP. Regarding the traffic trend of R1 accessing 172.20.1.4/32, which of the following analysis is correct? (Multiple choice)

Which of the following statements about the MP_REACH_NLRI attribute of BGP4+ is correct? (Multiple choice)

正解:A,B,C 解答を投票する
What are the correct descriptions of the resources that can be managed in the eSight subnet? (Multiple choice)

正解:B,C,D 解答を投票する
Which protocol modules can BFD detection be associated with? (Multiple choice)

正解:A,B,C,D 解答を投票する
Which of the following limitations of traditional networks do not include?

Through the display ip interface GE0/0/0 command, you can view the statistics of ping packets received on this interface.

Which of the following BGP routing attributes cannot control BGP routing?