JN0-352試験無料問題集「Juniper Enterprise Routing and Switching, Specialist (JNCIS-ENT) 認定」

You are configuring a GRE tunnel between Router A (192.168.1.1) and Router B (192.168.2.1) to connect two isolated networks. The tunnel interfaces (gr-0/0/0) need to support IPv4 traffic. In this scenario, which configuration ensures the tunnel endpoints are correctly defined and reachable?

解説: (GoShiken メンバーにのみ表示されます)
When trying to commit the configuration shown in the exhibit, you receive an error.
What is the problem?

Which three protocols support BFD? (Choose three.)

正解:A,B,E 解答を投票する
解説: (GoShiken メンバーにのみ表示されます)
You need to apply a Layer 2 firewall filter on a Juniper Networks EX Series Switch to block traffic from the source MAC address 00:12:34:56:00:07 entering the switch on ge-0/0/3. After committing the configuration, traffic from the MAC address still passes through. Referring to the exhibit, which statement is correct in this scenario?

解説: (GoShiken メンバーにのみ表示されます)
Which statement describes how a generated route determines its next hop?

解説: (GoShiken メンバーにのみ表示されます)
A Juniper Networks EX Series Switch has storm control enabled on all interfaces. The ge-0/0/1 interface carrying several VLANs hits its storm control limit and is shut down. In this scenario, which command allows you to manually clear the violation?

解説: (GoShiken メンバーにのみ表示されます)
You are required to ensure that Switch 1 will always be designated as the root bridge when participating in your switched network. What do you need to do to satisfy this requirement?

解説: (GoShiken メンバーにのみ表示されます)
What are two interarea OSPF LSA types? (Choose two.)

In addition to the MAC addresses, what information is stored in the bridging table? (Choose two.)

Your GRE tunnel is not transitioning to the Upstatus. What would be the first step in troubleshooting the problem?

You want to verify prefix information being sent from 10.36.1.4.
Which two statements are correct about the output shown in the exhibit? (Choose two.)

解説: (GoShiken メンバーにのみ表示されます)