JN0-681試験無料問題集（68題）「Juniper Data Center, Professional (JNCIP-DC) 認定」

出題：1

Which protocol is used between VCF member devices to create a loop-free topology?

A. MDTP

B. VCCP

C. RSTP

D. LLDP

正解：B 解答を投票する

出題：2

Which two statements describes an IP fabric? (Choose two.)

A. Each leaf should have a connection to each spine.

B. Traffic should always follow a single path

C. xSTP protocols should be used to prevent loops

D. Open standards allow for vendor interoperability.

正解：A,D 解答を投票する

出題：3

Referring to the exhibit, DC1 and DC2 have a DCI across a service provider WAN connection. Host1 in DC1 must have Layer 2 connectivity to host2 in DC2. A VXLAN tunnel must be created between VTEP1 and VTEP2.

In this scenario, which statement is true?

A. The service provider WAN connection be an MPL5-based WAN connection.

B. A route to the loopback address on VTEP must be present on VTEP1.

C. VXLAN Layer 3 gateway must be provisioned at the Super Spine layer.

D. VTEP and VTEP2 must peer using IBGP.

正解：B 解答を投票する

出題：4

You are asked to configure VXLAN for you c data center using multicast to exchange VTEP information?
In this scenario, which two configuration parameters must match on the VTEPs in the same VXLAN segment? (Choose two.)

A. Multicast group

B. Routing instance name

C. VLAN ID

D. VNI

正解：A,D 解答を投票する

出題：5

When using EBGP as the underlay protocol for your IP fabric architecture, which two statements are true? (Choose two.)

A. Spine nodes peer to both leaf and spine nodes

B. Leaf nodes only peer to spine nodes

C. Leaf nodes peer to both spine and leaf nodes

D. Spine nodes only peer to leaf nodes

正解：B,D 解答を投票する