NS0-509試験無料問題集（150題）「Network Appliance NetApp Certified Implementation Engineer

出題：1

Click the Exhibit button.

You notice that your volume named vol1 has a temporary volume that is doubling the space that is used by the volume.
In this scenario, which operation caused the volume to take up twice the space?

A. SnapMirror

B. FlexClone

C. SnapRestore

D. FlexGroup

正解：A 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：2

An SVM's LUN setup needs to have LIFs that are configured for FC access and iSCSI access. The administrator will also be using NetApp Virtual Storage Console.
In this scenario, which three types of LIFs are required? (Choose three.) FC LIFs

A. intercluster LIFs

B. NAS data LIFs

C. management LIFs

D. iSCSI data LIFs

正解：B,C,D 解答を投票する

出題：3

A customer has an FC host that needs to be attached to the NetApp AFF A700 dual controller storage cluster.
To accomplish this task, which three steps should the customer perform? (Choose three.)

A. Configure the FCP service for the node that has the LUN that is being accessed.

B. Confirm that the FC HBA driver and firmware is supported according to the Interoperability Matrix Tool (IMT)

C. Configure an igroup with the WWPN from the host initiator for LUN access.

D. Configure portsets to support the availability of multiple paths.

E. Confirm that the switch firmware is supported according to the Interoperability Matrix Tool (IMT).

正解：C,D,E 解答を投票する

出題：4

You have a 4-node cluster with an AFF A300 HA pair and a FAS8200 HA pair. You plan on using the default storage efficiency settings. With inline data compaction, you estimate that you can save 6% of storage space. AFF A300 volumes that use under 5000 IOPS are moved to a FAS8200 using the volume move command.
In this scenario, what happens to the data after the volume is moved? (Choose two.)

A. The new written data is compacted.

B. The existing data is compacted.

C. The existing data is not compacted.

D. The new written data is not compacted.

正解：D 解答を投票する

出題：5

An administrator needs to connect a new VMware 6.5 cluster to an ONTAP cluster for iSCSl connectivity. Which two steps would accomplish this task? (Choose two.)

A. Install the Virtual Storage Console for VMware vSphere.

B. Configure zoning for the HBAs and the ONTAP data LIFs.

C. Enable iSCSl adapters on the ESXi hosts.

D. Configure ALUA on the ONTAP SVM.

正解：C,D 解答を投票する

出題：6

Exhibit:

The exhibit shows the Inn show command output for the oradata oraFinProd_l LUN.
Which two statements ate correct about the LUN'? (Choose two.)

A. The LUN Is thick provisioned.

B. The LUN type is Windows.

C. The LUN supports SCSI Tin unmap.

D. The LUN is thin provisioned.

正解：C,D 解答を投票する

出題：7

Exhibit:

You are asked to serve iSCSI LUNs in an existing SVM on your AFF A220 using ONTAP 9.5. You verified that the iSCSI license is configured on your cluster and that the iSCSI protocol is enabled.
Referring to the exhibit, what is needed to allow hosts to log into the iSCSI target?

A. Map LUNs to the igroups.

B. Add iSCSI to the data protocol of the existing LIFs.

C. Create new igroups with the host IQNs.

D. Create new LIFs with the iSCSI data protocol.

正解：A 解答を投票する

出題：8

An enterprise customer has both a NetApp FAS8200 4-node cluster and a third-party storage array in a shared SAN environment. The host servers connect to both storage vendors' arrays in the fabric.
Regarding (he hosts in this scenario, what are- two NetApp best practices when performing this task? (Choose two.)

A. Always use the same adapter for heterogeneous storage systems.

B. Provide isolation between storage systems using NetApp's multitenancy feature.

C. Set the default timeout values and storage parameters for the host system.

D. Use separate adapters to connect to each vendors' storage system.

正解：C,D 解答を投票する

出題：9

You recently bought a FAS8200 series with SAS drives and want to maximize data efficiencies. Performance is not a primary Which two statements are correct in this scenario? (Choose two.)

A. Enable always-on deduplication.

B. Enable always-on compaction.

C. Enable both inline and post process efficiencies.

D. Enable compression.

正解：A,C 解答を投票する

出題：10

Exhibit:

You want to map a LUN to a server.
To which SAN object is the highlighted value in the exhibit added?

A. FlexClone

B. igroup

C. fabric zone

D. LUN

正解：B 解答を投票する

NS0-509試験無料問題集「Network Appliance NetApp Certified Implementation Engineer - SAN, ONTAP 認定」