CWDP-303試験無料問題集（60題）「CWNP Certified Wireless Design Professional 認定」

出題：1

After designing and deploying a WLAN infrastructure, you realized the CCI is causing poor performance in the 2.4 GHz band. Primarily, you've designed the WLAN for 5 GHz and 2.4 GHz as a best effort. You found out that the implementers didn't follow your guidelines when configuring the WLAN infrastructure. What can you do to minimize as much as possible the CCI impact in the 2.4 GHz band?

A. Increase the transmit power on all APs

B. Turn-off 2.4 GHz radios on some APs

C. Add more APs to the infrastructure

D. Use all channels available in the 2.4 GHz band

正解：B 解答を投票する

出題：2

In addition to a copy of your design, which tools should you use to ensure the installation team deploys APs where you have them designed to be located?

A. RF spectrum analyzer and packet capturing software

B. Camera and marking tools

C. Ladder and a pen

D. GPS and a map

正解：D 解答を投票する

出題：3

What is the most suitable antenna option to be used when designing a WLAN infrastructure with APs mounted on a ceiling with a height of more than 20 feet and having all of the client stations used from the floor?

A. Grid

B. Patch

C. Low-gain dipole

D. Dish

正解：A 解答を投票する

出題：4

You have performed a validation site survey after deploying a WLAN infrastructure that is an All-Wireless-Office. One specific application of your customer is experiencing delay when using the application after moving from wired connectivity. After your validation, you realized that all APs are using 80 MHz channel-widths instead of 20 MHz on the 5 GHz band, as it was designed. What can be done to resolve the delay on this application?

A. Power-off half of the APs to reduce CCI and keep 80 MHz channel-widths

B. APs should be using 160 MHz channel-widths to get more throughput

C. Reconfigure to use 20 MHz channel-widths, so reuse of the frequency is more effective

D. Add more APs using 80 MHz channel-widths

正解：C 解答を投票する

出題：5

While performing a validation site survey, you realize that overlapping channels are being used on the 2.4 GHz bad due to the automatic channel assignment algorithm of the WLAN infrastructure. What should you do to prevent this?

A. Purchase and deploy new APs from a different vendor

B. Reconfigure the network to use static channel plans because automatic channel assignment algorithms are all broken

C. Leave it as it is; sometimes using all 11 channels in 2.4 GHz gives the optimum performance result

D. Reconfigure the automatic channel assignment settings to use only channels 1, 6, and 11

正解：D 解答を投票する

出題：6

During a validation site survey, you realize that the installers mounted some of the APs above the ceiling.
They said that this was a request from the building architect due to aesthetics constraints. During the requirements gathering, you weren't advised about any aesthetics constraints from the main stakeholder of the project. What should you do in this case?

A. Remove all external antennas and use only the internal antennas to reduce multipath.

B. Advise the stakeholder that WLAN performance requirements will not be met and a new design process will be needed to meet the requirements.

C. Increase the output power on all APs by 6 dB immediately.

D. Leave it as it is and allow automatic channel management to correct any issues.

正解：B 解答を投票する

CWDP-303試験無料問題集「CWNP Certified Wireless Design Professional 認定」