300-815試験無料問題集（243題）「Cisco Implementing Cisco Advanced Call Control and Mobility Services 認定」

出題：1

An administrator is troubleshooting call failures on an H.323 gateway via the CLI. To see signaling for media and call setup, which debug must the Administrator turn on?

A. debug H.323 asn 1

B. debug H.225 media

C. debug H.224 asn1

D. debug H.323 messages

E. debug H.246 asn 1

正解：C 解答を投票する

出題：2

What is a capability of the gateway-preferred, network-based recording option in Cisco UCM?

A. It uses BIB of IP phone to fork audio to the recording destination.

B. Cisco UCM integrates with recording destination via SIP trunk.

C. It requires SIP trunk and CTI with recording application.

D. It initiates when the application (recorder) dictates that it must be initiated.

正解：B 解答を投票する

出題：3

An administrator configured Extension Mobility on Cisco UCM. Users report that logins are successful, but the phones do not have an Extension Mobility option after logging in. The administrator verified that Extension Mobility is enabled on the devices and that the log-out profile is valid. Which action must the administrator take to resolve the issue?

A. Change the Extension Mobility URL from HHTP to HTTPS.

B. Delete the identity trust list file from the phone(s).

C. Restart the Cisco Extension Mobility and Cisco Extension Mobility application services.

D. Subscribe all device profiles to the Extension Mobility phone service.

正解：D 解答を投票する

出題：4

A user's phone is already configured for Single Number Reach, and the user wants a feature to move an active call from a mobile phone to a desk phone and vice-vers a. As an administrator, which additional configuration should be made to fulfill the user's request?

A. Add the mobility key to the softkey template that the desk phone is using.

B. Use Dialed Number Analyzer to determine if the user extension can dial the mobile phone.

C. Confirm that the desk phone is subscribed to Cisco Extension Mobility.

D. Check to make sure that the Resume softkey option appears on the desk phone.

正解：A 解答を投票する

出題：5

An administrator has a requirement that the agents that receive calls from PSTN now must have a queue to hold the calls until they can be answered, but the customer cannot afford a contact center solution. The administrator discovered a feature called Native Call Queueing on Cisco UCM. Where must the administrator configure Native Call Queueing functionality?

A. hunt list

B. CTI route point

C. hunt pilot

D. hunt group

正解：C 解答を投票する

出題：6

An administrator is troubleshooting call failures on an H.323 gateway via the CLI. To see signaling for media and call setup, which debug must the Administrator turn on?

A. debug H.225 asn1

B. debug H.323 asn 1

C. debug H.225 media

D. debug H.323 messages

E. debug H.246 asn 1

正解：A 解答を投票する

出題：7

Refer to the exhibit.

Refer to the exhibit. An engineer is troubleshooting an issue where inbound Calls are failing after they transferred. The provider reports that update is not supported, and this is causing the calls to fail. Which command should resolve this issue?

A. no contact-passig

B. rel1xx require "100rel"

C. no update-callerId

D. no midcall-signaling passthru

正解：B 解答を投票する

出題：8

An administrator is working on an issue between the customer s Cisco Unified Border Element and the service provider. The provider only wants to see mid-call signaling from the Cisco Unified Border Element for fax calls. Which command must be configured on Cisco Unified Border Element?

A. midcall-signaling passthru media-change

B. midcall-signallng passthru

C. midcall-signaling preserve-codec

D. no update-callerid

正解：A 解答を投票する

出題：9

Calls to a particular extension are not routing to voicemail. The user reaches the voicemail system from the handset by pressing the Messages button Which configuration parameter causes this problem?

A. The voicemail pilot number for call forwarding is missing from the ephone

B. The voicemail pilot number for call forwarding is missing from the ephone-dn

C. The voicemail pilot number is missing from the telephony service configuration on Cisco UCME

D. The voicemail pilot number is missing from the call handling on Cisco Unity Express

正解：B 解答を投票する

出題：10

Which set of commands binds SIP media and signaling to interface GigabitEthernet0/0 when dial peer 1 is chosen for call routing?

A. voice service voip
bind sip source-interface GigabitEthernet0/0

B. voice service voip
sip
bind all source-interface GigabitEthernet0/0

C. dial-peer voice 1 voip
voice-class source interface GigabitEthernet0/0

D. dial-peer voice 1 voip
voice-class bind control source-interface GigabitEthernet0/0
voice-class sip bind media source-interface GigabitEthernet0/0

正解：B 解答を投票する

出題：11

A customer has multisite deployments with a globalized dial plan. The customer wants to route PSTN calls via the gateway assigned to each site. Which two actions will fulfill the requirement? (Choose two.)

A. Create a route group which has all the gateways and associate it to the device pool of every site.

B. Create a hunt group and assign it to each side route pattern

C. Create one global route list for PSTN calls that points to one global PSTN route group.

D. Assign one route group as a local route group in the device pool of the corresponding site.

E. Create one route group for each site and one global route list for PSTN calls that point to the local route group.

正解：D,E 解答を投票する

出題：12

If all patterns below are configured in Cisco Unified Communications Manager which would be used when dialing the pattern "123"?

A. 12[2-5]

B. 1XX (urgent Priority Set)

C. 12!

D. 12X (urgent priority set)

正解：A 解答を投票する

300-815試験無料問題集「Cisco Implementing Cisco Advanced Call Control and Mobility Services 認定」