EW0-300試験無料問題集（158題）「Extreme Networks Specialist.... 認定」

出題：1

What is true of a Rendezvous Point in PIM-DM?

A. It is the meeting point for PIM sources and the bootstrap router.

B. In PIM-DM you don't need a Rendezvous point.

C. It is the distribution point for multicast streams from the Mbone into an AS.

D. It is the meeting point for PIM sources and receivers.

正解：B 解答を投票する

出題：2

The Summit 7i switch supports how many queues per interface?

A. 8

B. 1

C. 4

D. 16

正解：A 解答を投票する

出題：3

In SLB a virtual server cannot belong to the same VLAN as the nodes in the referenced pool.

A. True

B. False

正解：A 解答を投票する

出題：4

SSH2 on Extreme Networks ? chipset switches enables encrypted telnet sessions towards the witch. SSH2 Client and Server both have a private key and exchange a public key before the connection is set-up.

A. FALSE

B. TRUE

正解：B 解答を投票する

出題：5

A QoS profile determines into which hardware queue a frame is enqueued.

A. True

B. False

正解：A 解答を投票する

出題：6

Select the statements that are true for IP multicast?

A. Multicast routers look at the source address to forward multicast traffic/

B. The destination address is always a multicast group address

C. A multicast server does not know each client host address

D. All of the above

正解：D 解答を投票する

出題：7

Identify the Summit chip switch that provides the following port density, 48 10/100 Ethernet ports and two unpopulated GBIC ports.

A. Summit 5i

B. Summit 1i

C. Summit 48i

D. Summit 50i

正解：C 解答を投票する

出題：8

Which CLI command would you use to configure vlan tracking towards vlan engineering for an ESRP protected VLAN manufacturing?

A. enable esrp add track-vlan engineering

B. enable vlan manufacturing add track-vlan engineering

C. config vlan manufacturing add track-vlan engineering

D. config esrp add track-vlan engineering

正解：C 解答を投票する

出題：9

VRRP is

A. A protocol standardized by the IEEE.

B. A protocol standardized by the IETF.

C. A protocol standardized by the ITU.

D. An Extreme Networks proprietary protocol.

正解：B 解答を投票する

出題：10

You have manually set the router-id now in order for an Extreme switch to use the numeric highest IP interface address as the OSPF router id on the next OSPF initialization, you will need to execute this CLI command.

A. configure routerid automatic

B. configure ospf routerid automatic

C. configure switch routerid 255

D. configure ospf routerid <router id>

正解：B 解答を投票する

EW0-300試験無料問題集「Extreme Networks Specialist.... 認定」