HP0-P10試験無料問題集（147題）「HP Integrity Server Multi-OS Installation and Deployment 認定」

出題：1

Where does HP OpenVMS store all error information?

A. SYS$MANAGER:OPERATOR.LOG

B. SYS$ERRORLOG:ERRLOG.SYS

C. /var/adm/syslog/syslog.log

D. SYS$ERRLOG:SYSTEM.LOG

正解：B 解答を投票する

出題：2

How can you determine the firmware version that is running on an HP Integrity system? (Select two.)

A. If you access the EFI Boot Manager menu using iLO, the firmware versions display automatically.

B. At the MP main menu, open the Command Menu (cm) and enter firmware.

C. At the EFI Boot Manager menu, open the EFI shell and enter info fw.

D. At the EFI Boot Manager menu, go to the Firmware menu and select Version.

E. At the EFI Boot Manager menu, go to the Firmware Configuration menu and select Version.

正解：A,C 解答を投票する

出題：3

Which Offline Diagnostics Environment (ODE) utility should you use to test an HP Tachyon XL2 Fibre Channel card?

A. IODIAG

B. FCFUPDATE

C. FCDIAG

D. PERFVER

正解：A 解答を投票する

出題：4

What is the MP command to configure an HP Integrity rx3600 for network access?

A. lanboot

B. sa

C. ls

D. lc

正解：D 解答を投票する

出題：5

DRAG DROP Using drag-and-drop, match the performance tool with the appropriate operating system. You can use a "Tool" answer box more than once.

正解：

出題：6

You are exploring the management processor on an HP Integrity rx2620 server. Which command in the MP Help menu displays all of the available commands?

A. LI

B. RX

C. DI

D. CM

正解：A 解答を投票する

出題：7

You need LAN access to the iLO 2 MP console of an Integrity rx6600 server. How can you set up the IP address?

A. At the EFI Shell, use the lanconfig command to assign a manual IP address to the MP LAN port.

B. Use the MP CA command to assign a manual IP address to the MP LAN port.

C. Use the MP LC command to enable DHCP for the MP LAN port.

D. At the EFI Shell, use ROUTE ADD <IP Address> MASK <Mask> <Gateway> to assign an IP address to the MP LAN port.

正解：C 解答を投票する

出題：8

There is a CD with a EFI file system in the CD/DVD drive. From the "EFI Shell>" prompt, which command do you use to access the drive?

A. sel0:

B. :0

C. fs0:

D. disk0

正解：C 解答を投票する

HP0-P10試験無料問題集「HP Integrity Server Multi-OS Installation and Deployment 認定」