HP2-T16試験無料問題集（123題）「HP Industry Standard Architecture and Technology 認定」

出題：1

What can you use to access the server console remotely when an operating system is not running? (Select two)

A. MS Terminal Services

B. Telnet

C. pcAnywhere solution

D. KVM switch with IP remote access

E. server emdedded remote management card

正解：D,E 解答を投票する

出題：2

Your RAID 5 array on a Smart Array sustains a drive failure.
A host spare replaces the failed drive and rebuilds successfully.
After replacing the failed drive with a new drive, what happens next?

A. The new drive re-assumes its place in the RAID set and after data rebuild is complete, the drive that was the spare once again becomes a hot spare drive.

B. The new drive stays offline until you assign it to the array, at which point it automatically takes the place of the spare drive.

C. The spare drive replicates its data to the new drive and both work as a mirror until you evict the spare drive.

D. The new drive becomes a spare drive and you must go to the ACU to remove the old spare drive and then re-add the new drive to the array.

正解：A 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：3

Which command can be used to verify connectivity to a client machine?

A. ping

B. nbstat

C. ipconfig

D. nslookup

正解：A 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：4

Which address range of the first octet is assigned to a TCP/IP class C network?

A. 128-191

B. 64-126

C. 1-64

D. 192-223

正解：D 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：5

After some analysis, you determine that more memory is needed to address a system bottleneck.
How do you incrase the memory and ensure the additional resources are effective to meet the need?

A. Add the memory and incrase the amount of the Paging File to equal the total amount of memory installed plus 10%

B. Establish a baseline performance report, install the new memory, create a new baseline report and compare it against expectations and the first baseline.

C. Add the memory and monitor perfmon counter % Usage Peak to verify that it is < 75%

D. Run Task Manager to check the amount of physical memory available, add the new memory and confirm the addition by running Task Manager again to show the new resources.

正解：B 解答を投票する

出題：6

Which material should be used for cleaning the ends of fibre optic cables?

A. polyester cloth

B. gravel

C. water

D. carbon dioxide

正解：A 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

HP2-T16試験無料問題集「HP Industry Standard Architecture and Technology 認定」