5V0-42.21試験無料問題集（53題）「VMware SD-WAN Design and Deploy Skills 認定」

出題：1

Which port is used for the high availability connection between the two Edges on a pair of Edge 510s?

A. GE1

B. GE4

C. SFP1

D. Any port may be chosen.

正解：C 解答を投票する

出題：2

An administrator is looking for a cost effective model of hardware-based Edge for some branch offices. The device must be mounted in rack cabinet, and to meet performance requirements and projected growth, the appliance must support up to 2 Gpbs bandwidth.
Which Edge model satisfies these requirements?

A. Edge 620

B. Edge 510

C. Edge 3400

D. Edge 540

正解：D 解答を投票する

出題：3

Which role(s) must be enable under Gateway configuration page to allow a VMware SD-WAN Gateway to build IPsec tunnels to non-VM SD-WAN?

A. Control Plane

B. Control Plane + Secure VPN Gateway

C. Control Plane + Data Plane + Partner Gateway

D. Control Plane + Data Plane + Secure VPN Gateway

正解：C 解答を投票する

出題：4

A service provider assigns two Partner Gateways to a VMware SD-WAN Edge.
Which description is correct about default route.

A. When handoff is turned off on a Partner Gateway, the Gateway does not advertise a default route 0.0 0.0/0 to the Edge.

B. It default route 0 0 0.010 has been configured for both Gateways, internet traffic originated from the Edge can failover to the other Gateway in case of a Gateway failure.

C. A default route 0.0.0.0/0 can be configured as a static route and set to NAT only on the Gateway

D. The service provider administrator decides whether the Partner Gateway advertises a default route 0.0.0.0/0 or not, although it is advertised by default.

正解：C 解答を投票する

出題：5

Due to very strict security policies an enterprise customer is looking for an on-premises deployment of the VMware SD-WAN Orchestrator and Controllers. Customer data is not expected to flow through this Controller, however it is desirable that management plane traffic towards the Orchestrator coming from VMware SD-WAN Edges can take the overlay tunnels through this controls.
What are some of the needed steps to achieve the requirements above?

A. Under gateway configuration -> Configure the Gateway roles as Control-Plane, enable Data Plane and Partner Gateway role and add static host mules with NAT hand off settings pointing to the Orchestrator IPs under Partner Gateway advanced hand off settings

B. Under gateway configuration -> Configure the Gateway roles as Control-Plane, enable Data Plant- and Partner Gateway role and add a static default route with NAT hand off settings under Partner Gateway advanced hand oft settings

C. Under gateway configuration -> Configure the Gateway roles as Control Plane, disable Data Plane and add static host routes with NAT hand off settings porting to the Orchestrator IPs under Partner Gateway advanced hand off settings

D. Under gateway configuration -> Configure the Gateway roles as Control Plane, disable Data Plane and enable management plane forward

正解：A 解答を投票する

出題：6

What Is a typical use case for the deployment of a VMware SU-WAN Partner Gateway?

A. Provide mite transport m a service provider backbone tor interconnecting a global customer SD-WAN branches.

B. Provide connectivity between multiple enterprise customers over private circuits

C. Get improved flow analytics for all traffic in the SD-WAN network

D. Interconnect branches/remote sites of a single enterprise customer to the internet

正解：A 解答を投票する

5V0-42.21試験無料問題集「VMware SD-WAN Design and Deploy Skills 認定」