合格させるNetwork Appliance NS0-593試験には練習テスト問題集豪華お試しセット
2023年最新の有効なNS0-593テスト解答とNetwork Appliance試験PDF問題を試そう
ネットワークアプライアンスNS0-593試験は、NetApp ONTAPストレージシステムをサポートする専門知識を検証しようとしているIT専門家向けに設計された認定試験です。この試験は、NetAppストレージシステムのトラブルシューティング、メンテナンス、パフォーマンスの最適化に関する候補者の知識を測定することを目的としています。 NS0-593試験は、NetApp Appecified Support Engineer ONTAPスペシャリスト認定の一部であり、NetAppストレージソリューションのサポートを提供する候補者のスキルの検証です。
NS0-593試験は、NetAppストレージシステムをサポートまたはメンテナンスの役割で扱うIT専門家を対象としています。これには、システム管理者、ストレージ管理者、技術サポートエンジニアが含まれます。この試験の候補者は、NetApp ONTAPストレージシステムに関する、インストール、構成、トラブルシューティングを含む堅牢な理解力を持っている必要があります。
ネットワークアプライアンスNS0-593（NetApp Certified Support Engineer ONTAP Specialist）試験は、NetAppストレージシステムのサポートとメンテナンスにおける候補者の専門知識を証明するために設計された業界で認められた認定試験です。この試験は、ONTAPソフトウェアを使用してNetAppストレージシステムを管理、トラブルシューティング、最適化する知識やスキルを向上させたい個人を対象としています。この認定試験は、彼らの組織でNetAppストレージシステムの管理とサポートを担当するプロフェッショナルに適しています。
質問 # 10
You have a 2-node NetApp FAS2750 switchless cluster with twenty-four 1.8 TB disks that is experiencing
performance issues. Upon investigation, you discover severaltype B consistency points.
Referring to the exhibit, which corrective action would address these consistency points?
- A. Replace the twenty-four 1.8 TB disks with twelve 4 TB disks.
- B. Convert the 2-node switchless cluster to a 2-node switched cluster.
- C. Create additional data LIFs.
- D. Add an additional shelf oftwenty-four 1.8 TB disks.
正解：D
質問 # 11
A 2-node cluster hosts only NAS data UFs. Allnodes lose access to the cluster network.
Referring to the exhibit, which statement is correct?
- A. No takeover event will occur and NAS data UFs will not be accessible.
- B. Both nodes race to takeover the other, one node will takeover the other node.
- C. NAS data UFs are accessible on only the node that has Epsilon.
- D. All nodes in the cluster reset and NAS data UFs are not accessible after reboot.
正解：D
質問 # 12
Your customer added a new DS4246 shelf to their FAS2750 single-node system and created a new aggregate
on the new shelf. Two weeks later, they log into Active IQ and discover the Medium Impact error shown
below.
Shelves with both connections via the same SAS path detected
Referring to the exhibit, which statement is correct?
- A. Active IQ Is not aware of the shelf configuration for a single-node system.
- B. The cables are cabled Incorrectly on the SAS stack.
- C. This situation is normal for a FA57750 single-node system.
- D. In a FAS2750 system, the internal shelf is only seen on one path, and the external shelves are seen on
two paths.
正解：C
質問 # 13
The motherboard of Node-01 is being replaced. To perform this task, a takeover was Initiated from Node-02.
Node-02 panics showing the string below.
PANIC; Permanent errors on all HA mailbox disks (while marshalling header) in SKprocess
fnmbx_instanceWorker on release 9.5P8 (C)
What has happened in this situation?
- A. While in maintenance mode, the HA_config show command was executed.
- B. While in maintenance mode, the mailbox destroy local command was executed.
- C. While in maintenance mode, the sldiag device show command was executed.
- D. While in maintenance mode, the fcadmin device_map command was executed.
正解：D
質問 # 14
After users start reporting the Inability to create new flies in a CIFS share, you find EMS events for
wafl.dir.size.max logged for the volume of the SVM to which the share points.
In this scenario, which action should you take to solve this issue?
- A. Delete unneeded files from the directory.
- B. Increase the maximum directory size for the volume.
- C. Move the volume to a different aggregate.
- D. Increase the maximum numberof files for the volume.
正解：D
質問 # 15
A storage administrator reports that a monitoring toot is reporting that the storage controller reads between
90% to 93% CPU use. You run the sysstat -m command against thenode in question.
Referring to the exhibit, which statement is correct?
- A. The CPU Is not a first-order monitoring metric for ONTAP.
- B. High network exempt use could be a problem.
- C. The customer should be advised to exclude certain workflows to reduce use.
- D. You should immediately investigate further bygathering perfstat data and opening a support case.
正解：D
質問 # 16
Which two automation methods does NetApp ONTAP Select support? (Choose two.)
- A. PHP
- B. REST
- C. Anslble
- D. Docker
正解：B、C
質問 # 17
Your customer is running a NetApp AFF A800 system with NetAppONTAP 9.8 software and states that their
NS224 shelf is not showing with the correct shelf ID. You analyze the data and the shelf shows an
identification of "1.SHFHUXXXXXXXXXX."
What is the cause of the reported Issue?
- A. A new shelf was added to the controller.
- B. The shelf was cabled Incorrectly.
- C. The shelf has been power cycled.
- D. The shelf had a disk replaced too quickly.
正解：A
質問 # 18
You created a new NetApp ONTAP FlexGroup volume spanning six nodes and 12 aggregates with a total size
of 4 TB. You added millions of files to the FlexGroup volume with a flat directory structure totaling 2 TB, and
you receive anout of apace error message on your host.
What would cause this error?
- A. The inode limit is exceeded in the ONTAP software.
- B. The maxdirsize Is exceeded in the ONTAP software.
- C. All constituent volumes are full.
- D. The maximum number of volume constituents has been reached in the ONTAP software.
正解：A
質問 # 19
You have a customer complaining of long build times from their NetApp ONTAP-based datastores. They
provided you packet traces from the controller and client. Analysis of these traces shows an average service
response time of 1 ms. QoS outputconfirms the same. The client traces are reporting an average of 15 ms in
the same time period.
In this situation, what would be your next step?
- A. The cluster is responding slowly and requires further investigation using performance archives.
- B. The cluster interconnects should be investigated.
- C. A sync core should be triggered.
- D. The client that reports high latency should be investigated.
正解：D
質問 # 20
You are deploying NetApp ONTAP Select. When trying to add VMware vCenter to the inventory, you receive
the message shown below.
Credential authentication failed for x.x.x.x with: HostConnectionFailed
In this scenario, how would you correct this problem?
- A. Change the gateway address of the ONTAP Select Deploy VM.
- B. Change the IP address of the ONTAP Select Deploy VM.
- C. Change the IP address of the vCenter server.
- D. Change the vCenter password.
正解：D
質問 # 21
A customer wants to connect a NetApp AFF A700 system to a 40GbE switch. The controllers have a 10/40G
Ethernet card in slot 4 for this purpose. The link comes up fine on node 2,but it will not come up on node 1.
You look at the AutoSupport data for the nodes in question and see the output shown in the exhibit.
What is the cause of the customer's problem?
- A. The ports are configured for 4x10Gbit instead of 40Gbit.
- B. The cable is plugged in upside down.
- C. The incorrect cable is used.
- D. The port has an incorrect SFP inserted.
正解：A
質問 # 22
When you review performance data for a NetApp ONTAP cluster node, there are back-to-back (B2B) type
consistency points (CPs) found occurring onthe loot aggregate.
In this scenario, how will performance of the client operations on the data aggregates be affected?
- A. Data aggregates will not be affected by B2B processing on another aggregate.
- B. During B2B processing, clients will be unable to write data.
- C. During B2B processing, all I/O to the node is stopped.
- D. During B2B processing, clients will be unable to read data.
正解：A
質問 # 23
You have a NetApp ONTAP cluster consisting of four NetApp FAS8200 controllers with two NetApp
CN1610 cluster switches running ONIAP 9.8 software. You are receiving several alert messages stating that
the cluster network has degraded. After troubleshooting, you determine that the errors are being generated
fromNode 2, interface e0b.
In this scenario, what should you do first to solve this problem?
- A. Replace the Twinax cable between Node 2, Interface e0b. and the NetApp CN1610 switch.
- B. Replace both NetApp CN1610 switches.
- C. Replace the NetApp CN1610 switch that connects to Node 2, interface e0b.
- D. Replace the motherboard on Node 2.
正解：D
質問 # 24
A user mentions that their home drive, that Is an export within a volume, is no longer allowing them to save
files. The drive reports that it Is full, even though It shows that minimal data is written to it.
Which statement would explain this behavior?
- A. The mount is stale and uses a cached version of the volume.
- B. The client system needs to remount the export to show the proper space.
- C. Other files within the volume are also owned by the user, exceeding the user quota.
- D. Other users wrote to this user's home drive.
正解：C
質問 # 25
After a normal power down of both nodes forbuilding maintenance, Node01 of a 2-node cluster cannot be
powered back up; however, all disk shelves are powered.
Which action should be performed to bring the cluster online and allow Node02 to serve data?
- A. Reboot the node With the system node reboot -node Node02 -bypass-optimization true command.
- B. Reinitialize the cluster with option 4a from the boot menu.
- C. Recreate the cluster with the system configuration recovery cluster recreate -from node command.
- D. Perform a takeover with the storage failover takeover -ofnode Node01 -option forcecommand.
正解：C
質問 # 26
......
トップクラスNetwork Appliance NS0-593オンライン問題集：https://www.goshiken.com/NetworkAppliance/NS0-593-mondaishu.html
無料Network Appliance NS0-593試験問題と解答トレーニングを提供しています：https://drive.google.com/open?id=1AlSygti9wvSmQKjy1ceLCg6X6EZJ2e0U