無料で使えるD-DP-DS-23試験ブレーン問題集認定ガイド問題と解答
D-DP-DS-23認定概要最新のD-DP-DS-23のPDF問題集
質問 # 46
A customer has a Dell EMC RecoverPoint Consistency Group that contains six Production volumes. Remote replication is needed to their disaster recovery site. Which factor determines the Protection window for this group?
Response:
- A. Number of RPAs in the Copy cluster and the size of the Copy Journal
- B. Change rate of the Production volumes and the size of the Copy Journal
- C. Change rate of the Production volumes and Write Splitter performance
- D. Number of RPAs in the Production cluster and the size of the Production Journal
正解：B
質問 # 47
In a Dell EMC NetWorker environment, what is the maximum number of cloud targets that can be served by a CloudBoost appliance?
Response:
- A. 0
- B. 1
- C. 2
- D. 3
正解：A
質問 # 48
You are designing a Dell EMC RecoverPoint for VMs solution. During the design meeting, you are asked where point-in-time copies are stored to allow failover to a previous state. What information should be provided to the customer?
Response:
- A. Older images are written to the Repository VMDK
- B. Previous images are stored in the Journal
- C. Copy vRPA memory holds each previous image
- D. Previous images are stored using the Copy storage
正解：B
質問 # 49
Which step is performed during the Advisory Phase of a Dell EMC Isolated Recovery Solution?
Response:
- A. Provide technology recommendations
- B. Develop run books and probability decision trees
- C. Provide compliance-ready test reports
- D. Deploy and harden the technology
正解：A
質問 # 50
A customer has a Dell EMC Data Domain system with a n action tier of 864 TB configured for Cloud Tier with two cloud units. What is the maximum storage capacity of each cloud unit?
Response:
- A. 1.3 PB
- B. 432 TB
- C. 1.7 PB
- D. 864 TB
正解：D
質問 # 51
Refer to the Exhibit.
A company wants to implement replication using Dell EMC Data Domain systems in multiple locations. They want to replicate data at their London site to and from the Madrid site. In addition, the company wants to replicate data at the London site to and from the Paris site.
How should the company's design requirements be addressed?
Response:
- A. Establish Bi-directional MTree replication between the sites
- B. Establish Bi-directional Collection replication between the sites
- C. Establish Collection replication between the sites
- D. Due to WAN speed limitations, replication between Madrid and London is not supported
正解：A
質問 # 52
You have been asked to perform as assessment of a customer''s environment. The customer has given complete to their IT staff and environment. During which stage of the assessment is it first learned about the databases, currently backup software, and growth rates in the environment?
Response:
- A. Interview phase
- B. Environment Analysis
- C. Assumptions versus Reality
- D. Design
正解：A
質問 # 53
A customer wants a technology refresh of their Dell EMC Networker environment. They want the ability to backup to disk devices. In addition, they want to write all backup-todisk devices with eight save sets simultaneously. After reviewing the current environment, you discover that only two drives are used.
Which setting should be change so that all are used simultaneously?
Response:
- A. Max session
- B. Devices parallelism
- C. Client parallelism
- D. Target sessions
正解：D
質問 # 54
Which TCP port is used for Dell EMC Avamar server SSL communications with the replication target server?
Response:
- A. 0
- B. 1
- C. 2
- D. 3
正解：B
質問 # 55
A system architect is designing a Dell EMC RecoverPoint for a VMs solution. During the design meeting, they are asked where point-in-time copies are stored to allow failover to a previous state. What information should be provided to the customer?
Response:
- A. Older images are written to the Repository VMDK.
- B. Previous images are stored in the Journal.
- C. Copy vRPA memory holds each previous image.
- D. Previous images are stored using the Copy storage.
正解：B
質問 # 56
In the Dell EMC Data Protection Suite for application, what is a benefits of storage Backup?
Response:
- A. Support for a wide range of third-party storage arrays
- B. Backup does not required Domain
- C. 10 faster recovery
- D. 10x faster backup
正解：B
質問 # 57
You have been asked to conduct a review of a customer's current Dell EMC NetWorker backup infrastructure. They are looking for configuration, capacity, and performance information. Which tool should be used?
Response:
- A. Workbench FSA Scan
- B. Dell EMC Backup System Sizer
- C. Live Optics
- D. Workbench GAP Analysis
正解：C
質問 # 58
A customer wants to perform a data center refresh. They want to standardize their backup infrastructure by using Dell EMC NetWorker and PowerProtect DD in an integrated environment. The environment consists of:
- A primary data center with NetWorker and PowerProtect DD
- A disaster recovery (DR) data center with only PowerProtect DD
All data is backed up to NetWorker using a DD Boost device. The data is then copied to the DR data center. Data for several critical systems must be retained for seven years on tape at the DR data center. In order to configure and track backup jobs, the entire solution must be managed from a single unified interface.
Which application interface should be used?
Response:
- A. PowerProtect DD Management Center
- B. Backup and Recovery Manager
- C. Data Protection Advisor
- D. NetWorker Management Console
正解：D
質問 # 59
Which requirement allows the Dell EMC RecoverPoint for VMs vRPAs to communicate with the ESXi servers hosting the Production or Copy VMs?
Response:
- A. Data interfaces of the vRPAs to the management address of the vCenter Server using TCP port 8800
- B. Data interfaces of the vRPAs to the VMkernel ports of the ESXi servers using IP
- C. Data interfaces of the vRPAs to the management address of the vCenter Server using TCP port 5760
- D. WAN interfaces of the vRPAs to the VMkernel ports of the ESXi servers using IP
正解：B
質問 # 60
How can the maximum capacity of 96 TB in the Dell EMC IDPA DP4400 fully utilized?
Response:
- A. Add additional capacity licenses with no additional hardware to purchase
- B. Configure capacity with ACM; additional capacity is detected after disks are inserted
- C. Set up full capacity during the deployment with IDPA System Manager
- D. Add disk packs of 12 TB and capacity licenses needed to be ordered
正解：A
質問 # 61
Which slop is performed during the Advisory Phase of a Dell EMC isolated Recovery Solution?
Response:
- A. Develop run books and probability decision trees
- B. Deploy and harden the technology
- C. Provide compliance-ready test reports
- D. Provide technology recommendations
正解：C
質問 # 62
A customer has two new Dell EMC integrated Data Protection Appliances and wants to back up to both applications bidirectional. The data centers are connected by a WAN link that will also be used by other mission critical applications.
To prepare for replication, the customer wants to co-locate both appliances at one data center and configure replication locally minimize the initial replication traffic.
After the initial synchronization, one unit will be relocated and the network reconfigured at the disaster recovery data center, What is mandatory for this solution to be deployed?
Response:
- A. Segregated replication interface
- B. Approved RPQ
- C. Minimum 1000 MB WAN link
- D. IDPA v2.2
正解：B
質問 # 63
A customer wants to monitor resources for the Dell EMC NetWorker server installed on the Microsoft Windows OS over a prolonged period of time. Which tool must be used to meet this requirement?
Response:
- A. perfmon
- B. iostat
- C. netstat
- D. vmstat
正解：A
質問 # 64
A system architect is designing a new Dell EMC NetWorker solution. After analyzing the environment, they have determined that they will need four storage nodes.
What should be done to increase the likelihood that the load is concentrated on a small number of storage nodes?
Response:
- A. Set the Save Session Distribution to Target sessions.
- B. Configure a low number of devices per storage node.
- C. Configure a high number of devices per storage node.
- D. Set the Save Session Distribution to Max sessions.
正解：D
質問 # 65
A customer is planning to deploy a Dell EMC Data Domain appliance. They want to provide users with the ability to copy files and data on their desktops or laptops to a mapped CIFS share created on the Data Domain. In addition, they want to replicate the share to another Data Domain Virtual Edition, either on-premises or in their public cloud.
Which recommended solution meets the customer''s requirements?
Response:
- A. Deploy Data Domain hardware on-premisesConfigure Directory replication to Data Domain in the public cloud
- B. Deploy Data Domain Virtual Edition in the public cloudConfigure MTree replication to Data Domain hardware on-premises
- C. Deploy Data Domain Virtual Edition in the public cloudConfigure Directory replication to Data Domain hardware on-premises
- D. Deploy Data Domain hardware on-premisesConfigure MTree replication to Data Domain in the public cloud
正解：D
質問 # 66
......
ベストなEMC D-DP-DS-23学習ガイドと問題集には2026：https://www.goshiken.com/EMC/D-DP-DS-23-mondaishu.html
トップクラスEMC D-DP-DS-23試験材料で学習ガイド！練習問題バージョンで挑もう：https://drive.google.com/open?id=1ZQkgnFxlzoEVni_kAwroUeNavqL1Moja