300-615PDF問題集で2022年02月04日試験問題 有効な300-615問題集
究極の300-615準備ガイドで無料最新のCisco練習テスト問題集
質問 14
Refer to the exhibit.
After the configuration is performed, guestshell continues to use 2%CPU. Which action resolves the issue?
- A. Reboot the switch
- B. Resync the database
- C. Recreate the guestshell
- D. Reboot the guestshell
正解: D
質問 15
A firmware upgrade on a fabric interconnect fails. A bootflash contains a valid image. Drag and drop the recovery steps from the left onto the correct order on the right.
正解:
解説:
質問 16
An engineer must place a Cisco UCS B-Series Server in a single server pool in Cisco UCS Manager. The engineer creates a qualification policy, but the server is still seen in multiple pools. Which two actions resolve the issue? (Choose two.)
- A. Select the Server Pool Policy Qualification from the qualification drop-down menu in the Server Pool Policy
- B. Select the Server Pool Policy from the qualification drop-down menu in the Server Pool Policy Qualification
- C. Set the operating system qualifier inside the Server Pool Policy Qualification
- D. Set the storage capacity qualifier inside the Server Poo. Policy Qualification.
- E. Set the number of vNICs qualifier inside the Server Pool Policy.
正解: A,C
質問 17
Refer to the exhibit.
The HSRP configuration in the exhibit fails to function. Which action resolves this issue?
- A. Enable IP redirects.
- B. Set the MTU to 1500 bytes.
- C. Configure the same HSRP group on both devices.
- D. Configure HSRP version 2.
正解: A
質問 18
An engineer troubleshoots a packet flow from an access leaf to a spine. Which EVPN routes are expected on this connection?
- A. EVPN Type 9-15
- B. EVPN Type 1-5
- C. EVPN Type 0 and 16
- D. EVPN Type 0, 9, and 15
正解: B
解説:
Section: Network
Explanation
質問 19
Refer to the exhibit.
An engineer troubleshoots the HSRP configuration and notes that the remote end uses HSRP version 1. The engineer sets the local HSRP to version 1, but the problem continues. Which action resolves the issue?
- A. Run version 1 and version 2 HSRP on VLAN300 in the local data center.
- B. Reduce the priority of the local HSRP to below 100 to force the local HSRP to standby and then change the version to version 1.
- C. Change the local group number to 255 or less and request that the remote data center matches the group member in its configuration.
- D. Set the local group number as 300 in the remote data center configuration
正解: C
解説:
Explanation
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipapp_fhrp/configuration/xe-16/fhp-xe-16-book/fhp-hsrp-v2.p
質問 20
Refer to the exhibit.
The HSRP instance on both switches is showing as active. Which action resolves the issue?
- A. Configure the IP address of N9K-B on the same subnet as N9K-A.
- B. Configure preempt on only one of the switches.
- C. Allow VLAN 100 between the switches.
- D. Configure the HSRP timers to be the same.
正解: C
質問 21
The external routes fail to propagate to leaf switches in Cisco ACI fabric. Which two actions resolve the issue?
(Choose two.)
- A. Configure an MP-BGP area.
- B. Assign an MP-BGP AS number to the fabric.
- C. Associate the correct contract to the L3Out.
- D. Specify the spine nodes as route reflectors.
- E. Enable the VTEP pool in the fabric.
正解: B,D
解説:
Section: Network
質問 22
A customer reports that the Chassis Management Controller fails to receive chassis information from Cisco UCS Manager. Which set of steps resolves the issue?
- A. 1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
3) Check for runtime link down status.
4) Reseat the affected IOM. - B. 1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels
2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
3) Check for runtime link down status
4) Reseat the affected IOM. - C. 1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels.
2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
3) Check for runtime link down status.
4) Reseat the affected IOM. - D. 1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
3) Check for runtime link down status
4) Reseat the affected IOM.
正解: D
解説:
Explanation
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ts/guide/UCSTroubleshooting/UCSTroubleshooti
質問 23
A firmware upgrade on a fabric interconnect fails. A bootflash contains a valid image. Drag and drop the recovery steps from the left onto the correct order on the right.
正解:
解説:
質問 24 
Refer to the exhibit. An OSPF adjacency between Router-A and Router-B fails to reach the FULL state. Which action resolves the issue?
- A. Set the OSPF media type to point-to-point.
- B. Disable the check of the MTU value.
- C. Adjust the MTU on Router-A to 1600.
- D. Adjust the MTU on Router-B to 1604.
正解: B
解説:
Section: Network
質問 25
Refer to the exhibit.
An engineer is investigating a role mapping issue on a switch. The users report that they cannot view the IP addresses under the tenant "corp". Which action resolves the issue?
- A. Configure the correct secret password between the APIC and the RADIUS server.
- B. Update the UNIX ID.
- C. Add the users to the RADIUS server.
- D. Add the updated avpair to include/corp/admin/
正解: A
質問 26
Refer to the Exhibit.
An Engineer cannot log in to the Cisco IMC page of the Cisco UCS C220 server. Which action resolve the issue?
- A. Use the DNS of the Cisco IMC webpage login page instead of the IP address for the connection to be secure.
- B. Replace the self-signed certificate that is installed on the Cisco IMC with a user certificate that is signed from the client corporate certificate.
- C. Replace the self-signed certificate that is installed on the Cisco IMC with a server certificate that is signed from the client corporate certificate.
- D. Se the FQDN of the Cisco IMC webpage login page instead of the IP address for the connection to be secure.
正解: C
質問 27
During a boot process of a Cisco UCS C-Series Rack Server, an engineer receives a "No Signal" message from the vKVM and physical connection. Which set of steps resolves the issue?
- A. 1- Power off the server and disconnect the power cord
2- Confirm that all cards are property seated
3- Connect the power cord and power on the server - B. 1- Disconnect the power cord
2- Confirm that all cards are properly seated
3- Connect the power cord - C. 1- Disconnect the power cord
2- Confirm that all cards are property seated
3- Connect the power cord and power on the server - D. 1- Power off the server and disconnect the power cord
2- Confirm that all cards are available
3- Connect the power cord and power on the server
正解: A
解説:
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/ts/guide/b_C-Series_Troubleshooting_Guide.pdf
質問 28
Refer to the exhibit.
A web browser displays a "not secure" warning message when accessing the web interface of Cisco UCS Manager. Which action resolves the issue?
- A. Use the correct TCP port for HTTPS.
- B. Load third-party certificate to UCS Manager.
- C. Use a supported web browser.
- D. Use a supported version of UCS Manager.
正解: B
質問 29
A mission-critical server is connected to site A. Connectivity to this server is lost from site B because the MAC route is missing in the OTV VDC of the Nexus 7000 in site B due to MAC aging. Which action allows the flooding of the unknown unicast MAC on the Nexus 7000 in the OTV VDC?
- A. Unknown unicast flooding is not allowed.
- B. Use the otv isis bfd <> command to configure BFD protocol.
- C. Use the otv flood mac <> command to selectively flood traffic for a given MAC.
- D. Use route-map to advertise this MAC statically and redistribute with ISIS.
正解: C
質問 30 
Refer to the exhibit. An OSPF adjacency between Router-A and Router-B cannot reach the FULL state. Which action resolves the issue?
- A. Set the OSPF media type to point-to-point.
- B. Disable the check of the MTU value.
- C. Adjust the MTU on Router-A to 1600.
- D. Adjust the MTU on Router-B to 1604.
正解: B
解説:
Section: Network
質問 31
Refer to the exhibit.
The EEM script overrides all events in the system policy. What should be added to the script to resolve the issue?
- A. environment variable
- B. event-default action statement
- C. configure terminal action
- D. event statement
正解: D
質問 32
Drag and drop the commands from the left onto the correct categories on the right.
正解:
解説:
質問 33
......
合格率 取得する秘訣は300-615認定試験エンジンPDF：https://www.goshiken.com/Cisco/300-615-mondaishu.html
今すぐ試そう！高評価Cisco 300-615試験問題集：https://drive.google.com/open?id=1LEWLnEz6tRxO4UOX1SNrslb-VXR4OCr2