問題集は全額返金保証付きのHPE6-A75問題集最大50%オフ
更新されたのは2023年10月合格させるHPE6-A75試験にはリアル練習テスト問題
HP HPE6-A75 認定試験は、Aruba エッジソリューションの設計、展開、管理を担当する IT プロフェッショナルのスキルと知識をテストするよう設計されています。この認定試験は、Aruba 有線および無線ソリューションを構成およびトラブルシューティングするために必要なスキルを検証し、ネットワーク管理と監視のための Aruba ソリューションのアクセスと使用方法を含めます。
質問 # 36
A company requires AOS-Switches at the campus core. The switches:
Will act as the default gateways for several campus VLANs
Must provide redundancy for their services and tolerate the loss of a link or an entire switch Must recover from the failure of one of the switches within a second or less VRRP and MSTP are proposed to meet these requirements. What is an issue with this proposal?
- A. VRRP provides routing redundancy but not default gateway redundancy.
- B. VRRP takes longer than a second to fail over.
- C. VRRP does not interoperate with MSTP.
- D. VRRP provides redundancy against lost links but not a failed switch.
正解：B
質問 # 37
Refer to the exhibit.
A known unicast packet is received from Switch-1 on the standby and must be forwarded to Switch-2. How does the VSF fabric decide which port in the aggregated (ink should forward the packet?
- A. The standby sends the packet to the commander over a VSF link, and the commander decides the correct port.
- B. The standby uses the typical load sharing algorithm, and it might select either its port or the commander's port.
- C. The standby selects the port on the designated forwarder for the aggregation.
- D. The standby uses its own port in the link aggregation to forward the fabric.
正解：D
質問 # 38
An AOS-Switch has type of service disabled on it globally. The administrator enters:
AOS-Switch(config)# interface 1 qos trust device aruba-ap
What is the effect of this command?
- A. if the AOS-Switch is integrated with an Aruba Mobility Controller, it uses QoS settings sent by the controller to classify traffic received on interface 1
- B. if interface connects to an Aruba AP, the switch marks all traffic received on the interface with a higher than default priority value
- C. if interface 1 connects to an Aruba AP, it uses the incoming DSCP and a global DSCP map to prioritize traffic received on this interface
- D. if the AOS-Switch is integrated with an Aruba Mobility Controller, it uses QoS settings send by the controller to prioritize traffic sent on interface 1
正解：D
質問 # 39
Refer to the exhibit.
- A. We can't know this from the screenshot above.
- B. john
- C. Employee
- D. mike
正解：A
解説：
The role field in the local user repository is not the role derived from role maping.
質問 # 40
Refer to the exhibit.
Based on the configuration of the Enforcement Profiles In the Onboard Authorization service shown, which Onboarding action will occur?
- A. The device will be disconnected from and reconnected to the network after Onboarding is completed.
- B. After logging in on the Onboard web login page, the device will be disconnected form and reconnected to the network before Onboard begins.
- C. The device will be disconnected from the network after Onboarding so that an EAP-TLS authentication is not performed.
- D. The device's onboard authorization request will be denied.
- E. The device will be disconnected after post-Onboarding EAP-TLS authentication, so a second EAP- TLS authentication is performed.
正解：A
質問 # 41
Refer to the exhibit.
Traffic between the servers m Area l takes a less optimal path rather than the link associated with VLAN l OOO, subnet 10.0.0.0/30. Based on the exhibits, why is this the case?
- A. The metric on the VLAN 1000 interface is too low.
- B. OSPF routing switches choose the best intra-area routes based on Area 1 links only.
- C. Switch-1 and Switch-2 cannot achieve adjacency on VLAN 1000 due to mismatches.
- D. The link between Switch-1 and Switch-2 has gone down.
正解：B
質問 # 42
OSPF is configured on an AOS-Switch, and the network administrator sets the router ID to
10.0.0.1. The administrator wants to be able to reach the switch at this ID from any location throughout the OSPF system. The administrator also needs the router ID to De stable and available, even if some links on the switch fail.
What should the administrator do?
- A. Configure 10.0.0.1 as a manual OSPF neighbor on each switch in the OSPF system.
- B. Configure 10.0.0.1 on a loopback interface, and enable OSPF on that interface.
- C. Make sure that 10.0.0.1 is the IP address on the VLAN with the lowest ID.
- D. Configure 10.0.0.1 as a secondary IP address on the switch 00BM poet.
正解：B
質問 # 43
A customer wants to implement Virtual IP redundancy, such that in case of a ClearPass server outage, 802.1x authentications will not be interrupted. The administrator has enabled a single Virtual IP address on two ClearPass servers.
Which statements accurately describe next steps? (Select two.)
- A. Both the primary and secondary nodes will respond to authentication requests sent to the Virtual IP address when the primary node is active.
- B. A new Virtual IP address should be created for each NAD.
- C. The NAD should be configured with the primary node IP address for RADIUS authentication on the 802.1x network.
- D. The primary node will respond to authentication requests sent to the Virtual IP address when the primary node is active.
- E. The NAD should be configured with the Virtual IP address for RADIUS authentications on the 802.1x network.
正解：D、E
質問 # 44
An AOS-Switch uses tunneled node. What is a best practice for the path between an AOS-Switch and its Mobility Controller?
- A. The path crosses no VLAN boundaries
- B. The path has a device that applies NAT
- C. The path implements MACsec
- D. The path can support jumbo frames
正解：D
質問 # 45
A company has AOS-Switches, Aruba ClearPass, and Aruba Airwave. A network administrator needs to set up a new switch with the same settings found on other switches in the company. Which action rs likely to be the most useful to perform the task?
- A. View usage patterns on the switches on AirWave.
- B. View the current running config on each switch.
- C. Use the configuration audit tool on AirWave.
- D. Access the Network Device view on ClearPass.
正解：D
質問 # 46
Refer to the exhibit.
An AD user's department attribute is configured as *HR". The user connects on Monday using their Windows Laptop to a switch that belongs to the Device Group HQ.
Which role is assigned to the user in ClearPass?
- A. Executive
- B. HR Local
- C. Remote Employee
- D. Vendor
- E. iOS Device
正解：B、C
質問 # 47
Refer to the exhibit. Several interfaces on an AOS-Switch enforce 802. IX to a RADIUS server at
10.254.378.521. The interface 802. IX settings are shown in the exhibit, and 802. IX is also enabled globally. The security team have added a requirement tor port security on the interfaces as well. Before administrators enable port security, which additional step must they complete to prevent issues?
- A. Set an 802. l X client limit on the interfaces.
- B. Enable DHCP snooping on VLAN 20.
- C. Manually add legitimate MAC addresses to the switch authorized MAC list.
- D. Enable eavesdropping protection on the interfaces.
正解：B
質問 # 48
A company has a mixed wireless and wired Aruba solution. It wants to encrypt messages used to send configurations and other important messages to the APs carried outside the GRE tunnels.
What can the company do to meet these goals?
- A. Deploy Aruba Meridian and integrate the AOS-Switches with it.
- B. Use PAPI enhanced security.
- C. Use tunneled node to send traffic through an Aruba Mobility Controller.
- D. Configure extended IP ACLs on the AOS-Switches to filter the traffic.
正解：C
質問 # 49
What is a primary use case for RPVST+ on AOS-Switches?
- A. more granular load balancing than MSTP when access switches connect to two core switches
- B. seamless integration with RSTP
- C. integration of AOS-Switches in a heterogeneous vendor network that uses the Cisco protocol
- D. enhanced loop protection in an MSTP network
正解：C
質問 # 50
Refer to the exhibit.
Traffic between the servers m Area l takes a less optimal path rather than the link associated with VLAN l OOO, subnet 10.0.0.0/30. Based on the exhibits, why is this the case?
- A. The metric on the VLAN 1000 interface is too low.
- B. OSPF routing switches choose the best intra-area routes based on Area 1 links only.
- C. Switch-1 and Switch-2 cannot achieve adjacency on VLAN 1000 due to mismatches.
- D. The link between Switch-1 and Switch-2 has gone down.
正解：B
質問 # 51
Which solution allows administrators to monitor link status and port utilization on AOS-Switches from a centralized location?
- A. Aruba Mobility Manager
- B. Aruba Mobility Controller
- C. Aruba ClearPass
- D. Aruba AirWave
正解：D
質問 # 52
......
Aruba認定エッジプロフェッショナル資格試験を受験する候補者は、Arubaソリューションの展開および管理の実務経験を持つことが推奨されます。また、Aruba Edgeトレーニングコースに参加することをお勧めします。このコースはAruba製品の展開および管理について包括的な理解を提供します。
無料ダウンロードHP HPE6-A75リアル試験問題：https://www.goshiken.com/HP/HPE6-A75-mondaishu.html
あなたを合格させる試験には100%検証済みのHPE6-A75試験問題：https://drive.google.com/open?id=19adqRczzs5oqXnBZbEvnmX9K6HIDv0uY