最近更新の2022年04月テストエンジンとPDFCisco 500-220テストあなたの最速Cisco合格準備を保証させる!
完全版500-220練習テスト58別格な問題と解釈が待ってます。今すぐゲット!
質問 15
Which two primary metrics does Meraki Insight use to calculate the Application Performance Score? (Choose two.)
- A. Maximum Jitter
- B. Application Response Time
- C. Maximum Latency
- D. Per-flow Goodput
- E. Total Bandwidth Usage
正解: B,D
質問 16
Which two actions can extend the video retention of a Cisco Meraki MV Smart Camera? (Choose two.)
- A. installing an SSD memory extension
- B. configuring a recording schedule
- C. enabling motion-based retention
- D. enabling maximum retention limit
- E. enabling audio compression
正解: B,C
質問 17
How does a Meraki device behave if cloud connectivity is temporarily lost?
- A. The offline device stops passing traffic.
- B. The offline device tries to form a connection with a local backup sever.
- C. The offline device continues to run with its last known configuration until cloud connectivity is restored.
- D. The offline device reboots every 5 minutes until connection is restored.
正解: B
質問 18
Which Cisco Meraki product must be deployed in addition to Systems Manager so that Systems Manager Sentry enrollment can be used?
- A. Meraki Insight
- B. MS Switch
- C. MV Smart Camera
- D. MR Access Point
正解: D
質問 19
Which design requirement is met by implementing syslog versus SNMP?
- A. when organization-wide information must be collected
- B. when proactive alerts for critical events must be generated
- C. when information such as flows and client connectivity must be gathered
- D. when automation capabilities are needed
正解: C
解説:
Reference:
Meraki_Device_Reporting_-_Syslog%2C_SNMP%2C_and_API
質問 20
Refer to the exhibit.
Which design recommendation should be considered?
- A. A 50-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 1-hop maximum.
- B. A 25-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 1-hop maximum.
- C. A 50-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 2-hop maximum.
- D. A 25-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 2-hop maximum.
正解: B
質問 21
Refer to the exhibit.
Which two actions are required to optimize load balancing asymmetrically with a 4:1 ratio between links? (Choose two.)
- A. Set the speed of the cellular uplink to zero.
- B. Change the assigned speeds of WAN 1 and WAN 2 so that the ratio is 4:1.
- C. Change the primary uplink to "none".
- D. Add an internet traffic preference that defines the load-balancing ratio as 4:1.
- E. Enable load balancing.
正解: D,E
質問 22
Refer to the exhibit.
The VPN concentrator is experiencing issues. Which action should be taken to ensure a stable environment?
- A. Add a deny any/any firewall rule to the end of the firewall rules.
- B. Configure the MX appliance to Routed mode on the Addressing & VLANS page.
- C. Physically disconnect all LAN ports.
- D. Remove the connection from Internet 1.
正解: C
質問 23
When an SSID is configured with Sign-On Splash page enabled, which two settings must be configured for unauthenticated clients to have full network access and not be allow listed? (Choose two.)
- A. Captive Portal strength
- B. Simultaneous logins
- C. Firewall & traffic shaping
- D. RADIUS for splash page settings
- E. Controller disconnection behavior
正解: A,E
質問 24
What is the role of the Meraki Dashboard as the service provider when using SAML for single sign-on to the Dashboard?
- A. The Dashboard generates the SAML request.
- B. The Dashboard generates the SAML response.
- C. The Dashboard provides user access credentials.
- D. The Dashboard parses the SAML request and authenticates users.
正解: A
質問 25
What occurs when a configuration change is made to an MX network that is bound to a configuration template?
- A. The configuration change in the bound network is combined with the template configuration inside the template.
- B. The template configuration overrides the configuration change in the bound network.
- C. The more restrictive configuration is preferred.
- D. The configuration change in the bound network overrides the template configuration.
正解: A
解説:
Reference:
Managing_Multiple_Networks_with_Configuration_Templates
質問 26
One thousand concurrent users stream video to their laptops. A 30/70 split between 2.4 GHz and 5 GHz is used.
Based on client count, how many APs (rounded to the nearest whole number) are needed?
- A. 0
- B. 1
- C. 2
- D. 3
正解: B
質問 27
Where should a network admin navigate to investigate wireless mesh information between Meraki APs?
- A. Wireless > Monitor > RF Spectrum
- B. Wireless > Monitor > Wireless Health
- C. Wireless > Configure > Radio Settings
- D. Wireless > Monitor > Access Points > AP > RF
正解: D
質問 28
Which API endpoint clones a new Organization?
- A. POST /organizations/{organizationId}/new
- B. POST /organizations/{organizationId}/clone
- C. POST /organizations/clone/{organizationId}
- D. PUT /organizations/{organizationId}/clone
正解: A
質問 29
When wireless SSIDs are configured in Dashboard, which setting on the Access Control page affects the ability of a 2.4 GHz only client device from associating to the WLAN for the first time?
- A. Dual band operating with Band Steering
- B. Content filtering
- C. Bridge mode
- D. 802.11r
正解: A
質問 30
Refer to the exhibit.
During a Meraki AP deployment, the default SSID that the exhibit shows is broadcast. What causes this behavior?
- A. An AP has Site Survey mode enabled.
- B. An AP has never connected to the Meraki Cloud Controller.
- C. An AP cannot connect to the default gateway.
- D. An AP does not have a wired connection to the network.
正解: B
解説:
Reference:
Troubleshooting_local_connection_issues_using_default_SSID_on_MR_Access_Points
質問 31
Refer to the exhibit.
What is an advantage of implementing inter-VLAN routing on an MX Security Appliance rather than performing inter-VLAN routing on an MS Series Switch?
- A. The MX appliance performs AMP for inter-VLAN traffic.
- B. The MX appliance performs content filtering for inter-VLAN traffic.
- C. The MX appliance performs IDS/IPS for inter-VLAN traffic.
- D. The MX appliance performs data encryption for inter-VLAN traffic.
正解: D
質問 32
Refer to the exhibit.
What are two outcomes reflected in the Web App Health application? (Choose two.)
- A. Network #2 had better application performance than Network #1.
- B. Neither network recorded any server-side performance issues.
- C. Network #2 could not load Google because of a local client misconfiguration.
- D. Users on both networks may be experiencing issues when attempting to reach Google.
- E. Network #1 could not load Google because of a remote server issue.
正解: B,E
質問 33
Which two features and functions are supported when using an MX appliance in Passthrough mode? (Choose two.)
- A. intrusion prevention
- B. secondary uplinks
- C. DHCP
- D. site-to-site VPN
- E. high availability
正解: A,D
解説:
Reference:
Passthrough_Mode_on_the_MX_Security_Appliance_and_Z-series_Teleworker_Gateway
質問 34
......
最新の500-220問題集試験問題を取得:https://drive.google.com/open?id=1OpO58slaJfE4AJDN-26Nz4aUSWOvkxW3
完全版500-220練習テスト58別格な問題と解釈が待ってます。:https://www.goshiken.com/Cisco/500-220-mondaishu.html