試験問題と解答は500-220学習ガイド問題を試そう！
Engineering Cisco Meraki Solutions認証サンプル問題と練習試験合格させます
質問 16
Refer to the exhibit.
The VPN concentrator is experiencing issues. Which action should be taken to ensure a stable environment?
- A. Physically disconnect all LAN ports.
- B. Remove the connection from Internet 1.
- C. Configure the MX appliance to Routed mode on the Addressing & VLANS page.
- D. Add a deny any/any firewall rule to the end of the firewall rules.
正解: A
質問 17
Refer to the exhibit.
This Dashboard organization uses Co-Termination licensing model.
What happens when an additional seven APs are claimed on this network without adding licenses?
- A. All network devices stop functioning in 30 days.
- B. All APs stop functioning in 30 days.
- C. All APs immediately stop functioning.
- D. One AP Immediately stops functioning.
正解: A
質問 18
Which type of authentication protocol is used when using OSPF on an MX appliance?
- A. certificate
- B. SHA-1
- C. plaintext
- D. MD5
正解: D
解説:
Reference:
Using_OSPF_to_Advertise_Remote_VPN_Subnets
質問 19
Which two primary metrics does Meraki Insight use to calculate the Application Performance Score? (Choose two.)
- A. Maximum Latency
- B. Application Response Time
- C. Per-flow Goodput
- D. Maximum Jitter
- E. Total Bandwidth Usage
正解: B,C
質問 20
What happens to an unsupervised iOS device when the "Meraki management" profile is removed?
- A. The "Meraki management" profile is removed. All configuration profiles that Systems Manager pushed are also removed.
- B. The "Meraki management" profile is removed and then pushed automatically by Systems Manager.
- C. The "Meraki management" profile cannot be removed.
- D. The "Meraki management" profile is removed. All configuration profiles that Systems Manager pushed remain.
正解: A
質問 21
Refer to the exhibit.
For an AP that displays this alert, which network access control method must be in use?
- A. splash page with my RADIUS server
- B. preshared key
- C. MAC-based access control with RADIUS server
- D. WPA2-enterprise with my RADIUS server
正解: B
質問 22
What is the best practice Systems Manager enrollment method when deploying corporate-owned iOS devices?
- A. DEP
- B. Apple Configurator
- C. Sentry enrollment
- D. manual
正解: B
質問 23
When an SSID is configured with Sign-On Splash page enabled, which two settings must be configured for unauthenticated clients to have full network access and not be allow listed? (Choose two.)
- A. Controller disconnection behavior
- B. RADIUS for splash page settings
- C. Captive Portal strength
- D. Firewall & traffic shaping
- E. Simultaneous logins
正解: A,C
質問 24
Refer to the exhibit.
What is the minimal Cisco Meraki Insight licensing requirement?
- A. A single Meraki Insight license must be configured on network B to gain Web App Health visibility on network B.
- B. A single Meraki Insight license must be configured on network A to gain Web App Health visibility on network B.
- C. Two Meraki Insight licenses must be configured on network A to gain Web App Health visibility on network B.
- D. A single Meraki Insight license must be configured on network A, and a single license must be configured on network B, to gain Web App Health visibility on network B.
- E. Two Meraki Insight licenses must be configured on network A and a single license must be configured on network B, to gain Web App Health visibility on network B.
正解: E
質問 25
Refer to the exhibit.
During a Meraki AP deployment, the default SSID that the exhibit shows is broadcast. What causes this behavior?
- A. An AP does not have a wired connection to the network.
- B. An AP cannot connect to the default gateway.
- C. An AP has never connected to the Meraki Cloud Controller.
- D. An AP has Site Survey mode enabled.
正解: C
解説:
Reference:
Troubleshooting_local_connection_issues_using_default_SSID_on_MR_Access_Points
質問 26
When wireless SSIDs are configured in Dashboard, which setting on the Access Control page affects the ability of a 2.4 GHz only client device from associating to the WLAN for the first time?
- A. Bridge mode
- B. 802.11r
- C. Dual band operating with Band Steering
- D. Content filtering
正解: C
質問 27
Refer to the exhibit.
Which design recommendation should be considered?
- A. A 50-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 1-hop maximum.
- B. A 25-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 1-hop maximum.
- C. A 25-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 2-hop maximum.
- D. A 50-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 2-hop maximum.
正解: B
質問 28
Refer to the exhibit.
A packet arrives on the VPN concentrator with source IP 10.168.70.3 and destined for IP 10.116.32.4.
What is the next hop for the packet, based on this concentrator routing table?
- A. The Auto VPN peer "Store 1532 - appliance" is the next hop.
- B. Not enough detail is available to determine the next hop.
- C. The concentrator gateway (10.128.124.62) is the next hop.
- D. The packet is stopped.
正解: B
質問 29
Drag and drop the settings from the left into the boxes on the right to indicate if the setting will be cloned or not cloned using the Cisco Meraki MS switch cloning feature.
正解:
解説:
質問 30
A customer requires a hub-and-spoke Auto VPN deployment with two NAT-mode hubs with dual uplink connections and 50 remote sites with a single uplink connection.
How many tunnels does each hub need to support?
- A. 0
- B. 1
- C. 2
- D. 3
正解: D
質問 31
Which Cisco Meraki product must be deployed in addition to Systems Manager so that Systems Manager Sentry enrollment can be used?
- A. MS Switch
- B. MR Access Point
- C. MV Smart Camera
- D. Meraki Insight
正解: B
質問 32
A new application needs to be pushed to all iOS devices. Some devices report "NotNow" in the event log and do not install the application.
What does the "NotNow" event indicate?
- A. The device cannot connect to Apple servers.
- B. The device cannot connect to Cisco Meraki servers.
- C. The application requires the most recent iOS version.
- D. The device is locked with a passcode.
正解: D
質問 33
Where should a network admin navigate to investigate wireless mesh information between Meraki APs?
- A. Wireless > Monitor > RF Spectrum
- B. Wireless > Monitor > Wireless Health
- C. Wireless > Monitor > Access Points > AP > RF
- D. Wireless > Configure > Radio Settings
正解: C
質問 34
Which two features and functions are supported when using an MX appliance in Passthrough mode? (Choose two.)
- A. intrusion prevention
- B. DHCP
- C. secondary uplinks
- D. high availability
- E. site-to-site VPN
正解: A,E
解説:
Reference:
Passthrough_Mode_on_the_MX_Security_Appliance_and_Z-series_Teleworker_Gateway
質問 35
What are two ways peers interact with ports that Auto VPN uses? (Choose two.)
- A. Peers contact the VPN registry at TCP port 9350.
- B. For IPsec tunneling, peers use UDP ports 500 and 4500.
- C. For IPsec tunneling, peers use high UDP ports within the 32768 to 61000 range.
- D. For IPsec tunneling, peers use high TCP ports within the 32768 to 61000 range.
- E. Peers contact the VPN registry at UDP port 9350.
正解: D,E
解説:
Reference:
_Configuration_and_Troubleshooting
質問 36
A customer wants to use Microsoft Azure to host corporate application servers.
Which feature does the customer get by using a vMX appliance rather than connecting directly to Azure by VPN?
- A. SD-WAN
- B. malware protection
- C. intrusion prevention
- D. next-generation firewall
正解: D
質問 37
Which information do the MXs in a High Availability pair share?
- A. time synchronization state
- B. stateful firewall database
- C. spanning-tree state
- D. DHCP association database
正解: C
質問 38
......
500-220認証問題集Cisco Meraki Solutions Specialist 500-220ガイド 100%有効：https://www.goshiken.com/Cisco/500-220-mondaishu.html
100%合格率の問題集を使ってあなたの500-220試験を一発合格：https://drive.google.com/open?id=1OpO58slaJfE4AJDN-26Nz4aUSWOvkxW3