[2023年07月]更新の200-301試験問題と有効な200-301問題集PDF
200-301ブレーン問題集学習ガイドにはヒントとコツで試験合格を目指そう
質問 # 314
Refer to the exhibit. A network engineer must provide configured IP addressing details to investigate a firewall rule issue.
Which subnet and mask Identify what is configured on the eth0 interface?
- A. 10.8.128.0/19
- B. 10.8.138.0/24
- C. 10.8.0.0/16
- D. 10.8.64.0/18
正解：B
質問 # 315
Which QoS Profile is selected in the GUI when configuring a voice over WLAN deployment?
- A. Bronze
- B. Platinum
- C. Silver
- D. Gold
正解：B
解説：
Section: Network Access
Explanation/Reference: https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/81831-qos-wlc- lap.html
質問 # 316
An engineer must configure a/30 subnet between two routers. Which usable IP address and subnet mask combination meets this criteria?
- A. Option A
- B. Option C
- C. Option B
- D. Option D
正解：A
質問 # 317
An engineering team asks an implementer to configure syslog for warning conditions and error conditions. Which command does the implementer configure to achieve the desired result?
- A. logging trap 2
- B. logging trap 5
- C. logging trap 3
- D. logging trap 4
正解：D
質問 # 318
Which two statements about an Ethernet frame source address are true? (Choose two.)
- A. The address is 4 bits long.
- B. The leftmost bit is always 0.
- C. The leftmost bit is always 1.
- D. The address is 4 bytes long
- E. The address is 6 bytes long.
正解：B、E
質問 # 319
When deploying syslog, which severity level logs informational message?
- A. 0
- B. 1
- C. 2
- D. 3
正解：B
解説：
Explanation
https://en.wikipedia.org/wiki/Syslog
質問 # 320
Drag and Drop Question
Drag and drop the descriptions of file-transfer protocols from the left onto the correct protocols on the right.
Select and Place:
正解：
解説：
質問 # 321
Refer to the exhibit.
An engineer must configure router R2 so it is elected as the DR on the WAN subnet. Which command sequence must be configured?
A)
B)
C)
D)
- A. Option
- B. Option
- C. Option
- D. Option
正解：A
質問 # 322
What differentiates device management enabled by Cisco DNA Center from traditional campus device management?
- A. per-device
- B. centralized
- C. device-by-device hands-on
- D. CLI-oriented device
正解：B
解説：
When using Cisco DNA Center to manage network device, device management is centralized and is managed from the DNA center GUI. Using DNA Center allows for us to have a more centralized management of network infrastructure as configuration changes can be applied to an many devices at once when these changes are done through DNA Center.
質問 # 323
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
正解：
解説：
質問 # 324
An engineer is tasked to configure a switch with port security to ensure devices that forward unicasts multicasts and broadcasts are unable to flood the port The port must be configured to permit only two random MAC addresses at a time Drag and drop the required configuration commands from the left onto the sequence on the right Not all commands are used.
正解：
解説：
質問 # 325
A network engineer is configuring an OSPFv2 neighbor adjacency Drag and drop the parameters from the left onto their required categories on the right. Not all parameters are used
正解：
解説：
質問 # 326
What does physical access control regulate?
- A. access to computer networks and file systems
- B. access to networking equipment and facilities
- C. access to spec fie networks based on business function
- D. access to servers to prevent malicious activity
正解：B
質問 # 327
What are two requirements for an HSRP group? (Choose two.)
- A. exactly one standby active router
- B. one or more standby routers
- C. one or more backup virtual routers
- D. exactly one backup virtual router
- E. exactly one active router
正解：B、E
解説：
A: exactly one active router: Only one Active Router per HSRP group will be elected based on highest priority. In case of equal priority, Highest IP address will be elected as Active Router.
B: one or more standby routers : There can be one or more Standby Routers.
C, D And E are incorrect: Wrong terminology.
質問 # 328
Which two actions influence the EIGRP route selection process? (Choose two)
- A. The router calculates the feasible distance of all paths to the destination route
- B. The router calculates the best backup path to the destination route and assigns it as the feasible successor.
- C. The router calculates the reported distance by multiplying the delay on the exiting Interface by 256.
- D. The router must use the advertised distance as the metric for any given route
- E. The advertised distance is calculated by a downstream neighbor to inform the local router of the bandwidth on the link
正解：A、B
解説：
Explanation
The reported distance (or advertised distance) is the cost from the neighbor to the destination. It is calculated from the router advertising the route to the network. For example in the topology below, suppose router A & B are exchanging their routing tables for the first time. Router B says "Hey, the best metric (cost) from me to IOWA is 50 and the metric from you to IOWA is 90" and advertises it to router A.
Router A considers the first metric (50) as the Advertised distance. The second metric (90), which is from NEVADA to IOWA (through IDAHO), is called the Feasible distance.
The reported distance is calculated in the same way of calculating the metric. By default (K1 = 1, K2 = 0, K3
= 1, K4 = 0, K5 = 0), the metric is calculated as follows:
質問 # 329
Drag and drop to the characteristics of networking from the left onto the correct networking types on the right.
正解：
解説：
質問 # 330
Drag and drop the AAA terms from the left onto the description on the right.
正解：
解説：
質問 # 331
Which output displays a JSON data representation?
- A. Option A
- B. Option C
- C. Option B
- D. Option D
正解：B
解説：
JSON data is written as name/value pairs. A name/value pair consists of a field name (in double quotes), followed by a colon, followed by a value: "name":"Mark" JSON can use arrays. Array values must be of type string, number, object, array, boolean or null. For example: { "name":"John", "age":30, "cars":[ "Ford", "BMW", "Fiat" ] } JSON can have empty object like "taskId":{}
質問 # 332
Refer to the exhibit.
What is the next hop address for traffic that is destined to host 10.0.1.5?
- A. Loopback D
- B. 10.0.1.3
- C. 10.0.1.50
- D. 10.0.1.4
正解：C
質問 # 333
Refer to the exhibit.
Only four switches are participating in the VLAN spanning-tree process.
Branch-1 priority 614440
Branch-2: priority 39082416
Branch-3: priority 0
Branch-4: root primary
Which switch becomes the permanent root bridge for VLAN 5?
- A. Branch-4
- B. Branch-1
- C. Branch-2
- D. Branch-3
正解：D
解説：
Dynamic ARP inspection is an ingress security feature; it does not perform any egress checking.
質問 # 334
Drag the descriptions of device management from the left onto the types of device management on the right.
正解：
解説：
Explanation
Cisco DNA Center Device Management
3. Monitor the cloud for software update
5. Uses CLI templates to apply a consistent configuration to multiple devices at an individual location
6. Uses NetFlow to analyse potential security threats throughout the network and take appropriate action on that traffic Traditional device management
2. Manages device configuration on a per-device basis
4. Security is managed near the perimeter of the network with firewalls, VPNs, and IPS
* Implements changes via an SSH terminal
質問 # 335
......
200-301試験問題無料PDFダウンロード 最近更新された問題です：https://www.goshiken.com/Cisco/200-301-mondaishu.html
200-301認定試験問題集には875練習テスト問題：https://drive.google.com/open?id=1DYeyRcRVijLq3LOGjJE9uFsWTgrU3p87