[2026年01月13日] 最新をゲットせよ！200-301認定練習テスト問題と試験問題集 [Q270-Q286]

[2026年01月13日] 最新をゲットせよ！200-301認定練習テスト問題と試験問題集

リアル200-301試験問題集解答で有効な200-301問題集PDF

Cisco 200-301試験では、あらゆるネットワークエンジニアまたは技術者に不可欠なさまざまなトピックをカバーしています。これらのトピックには、ネットワークの基礎、ネットワークアクセス、IP接続、IPサービス、セキュリティの基礎、自動化とプログラマ性が含まれます。また、この試験では、ネットワークデバイスの構成、トラブルシューティング、管理機能、およびワイヤレスネットワーキングとネットワークアーキテクチャに関する知識について候補者をテストします。

シスコ認定ネットワークアソシエイト（CCNA）認定資格は、IT業界で最も広く認知され尊重される資格の1つです。この認定は、小規模から中規模の企業ネットワークをインストール、構成、運用、トラブルシューティングするために必要な基本的な知識とスキルをテストするために設計されています。最新版のCCNA認定試験は、2020年2月に導入されたCisco 200-301です。

質問 # 270
Drag and drop the application protocols from the left onto the transport protocols that it uses on the right

正解：

解説：

質問 # 271

Refer to the exhibit. The DHCP server is configured with a DHCP pool for each of the subnets represented.
Which command must be configured on switch SW1 to allow DHCP clients on VLAN 10 to receive dynamic IP addresses from the DHCP server?

A. SW1(config-if)#ip helper-address 192.168.10.2
B. SW1(config-if)#ip helper-address 192.168.20.2
C. SW1(config-if)#ip helper-address 192.168.10.1
D. SW1(config-if)#ip helper-address 192.168.20.1

正解：A

質問 # 272
A switch is configured with all ports assigned to vlan 2 with full duplex FastEthernet to segment existing departmental traffic.
What is the effect of adding switch ports to a new VLAN on the switch?

A. More collision domains will be created.
B. IP address utilization will be more efficient.
C. An additional broadcast domain will be created.
D. More bandwidth will be required than was needed previously

正解：C

質問 # 273
Refer to the exhibit.

A network engineer must update the configuring on switch2 so that it sends LLDP packets.

正解：D

質問 # 274
What is a function of Wireless LAN Controller?

A. monitor activity on wireless and wired LANs
B. send LWAPP packets to access points.
C. use SSIDs to distinguish between wireless clients.
D. register with a single access point that controls traffic between wired and wireless endpoints.

正解：B

解説：
Lightweight APs (LAPs) is devices require no initial configuration. LAPs use the Lightweight Access Point Protocol (LWAPP) to communicate with a WLAN controller (WLC), as shown in the below figure.
Controller-based APs are useful in situations where many APs are required in the network. As more APs are added, each AP is automatically configured and managed by the WLC.

質問 # 275
Refer to the exhibit.

which path is used by the router for internet traffic ?

A. 0.0.0.0/0
B. 209.165.200.0/27
C. 10.10.13.0/24
D. 10.10.10.0/28

正解：A

質問 # 276
Refer to the exhibit.

Which switch becomes the root of the spanning tree for VLAN 110?

A. Switch 1
B. Switch 3
C. Switch 4
D. Switch 2

正解：D

質問 # 277
Refer to the exhibit.

The network administrator must prevent the switch Cat9K-2 IP address from being visible in LLDP without disabling the protocol. Which action must be taken must be taken to complete the task?

A. Configure the no lldp tlv-select-management-address command globally on Cat9K-2
B. Configure the no lldp transmit command on interface G1/0/21 in Cat9K-1
C. Configure the no lldp receive command on interface G1/0/21 on Cat9K-1
D. Configure the no lldp mac-phy-cfg command globally on Cat9K-2

正解：A

質問 # 278
Drag and drop the descriptions of AAA services from the left onto the corresponding services on the right.

正解：

解説：

Explanation:

質問 # 279
Which two actions influence the EIGRP route selection process? (Choose two.)

A. The router must use the advertised distance as the metric for any given route.
B. The router calculates the feasible distance of all paths to the destination route.
C. The advertised distance is calculated by a downstream neighbor to inform the local router of the bandwidth on the link.
D. The router calculates the reported distance by multiplying the delay on the exiting interface by 256.
E. The router calculates the best backup path to the destination route and assigns it as the feasible successor.

正解：B、E

解説：
Section: IP Connectivity
Explanation:
The reported distance (or advertised distance) is the cost from the neighbor to the destination. It is calculated from the router advertising the route to the network. For example in the topology below, suppose router A & B are exchanging their routing tables for the first time. Router B says "Hey, the best metric (cost) from me to IOWA is 50 and the metric from you to IOWA is 90" and advertises it to router A. Router A considers the first metric (50) as the Advertised distance. The second metric (90), which is from NEVADA to IOWA (through IDAHO), is called the Feasible distance.

The reported distance is calculated in the same way of calculating the metric. By default (K1 = 1, K2 = 0, K3
1, K4 = 0, K5 = 0), the metric is calculated as follows:

Feasible successor is the backup route. To be a feasible successor, the route must have an Advertised distance (AD) less than the Feasible distance (FD) of the current successor route.
Feasible distance (FD): The sum of the AD plus the cost between the local router and the next-hop router. The router must calculate the FD of all paths to choose the best path to put into the routing table.
Note: Although the new CCNA exam does not have EIGRP topic but you should learn the basic knowledge of this routing protocol.

質問 # 280
Which type of organization should use a collapsed-core architecture?

A. large and requires a flexible, scalable network design
B. small but is expected to grow dramatically in the near future
C. large and must minimize downtime when hardware fails
D. small and needs to reduce networking costs currently

正解：D

解説：
A collapsed-core architecture is a limited investment for a small company, and may be efficient and productive for a limited time.

質問 # 281
Refer to the Exhibit.

After the switch configuration the ping test fails between PC A and PC B Based on the output for switch 1.
which error must be corrected?

A. The PCs are m the incorrect VLAN
B. All VLANs are not enabled on the trunk
C. There is a native VLAN mismatch
D. Access mode is configured on the switch ports.

正解：C

質問 # 282
Drag and Drop Question
Refer to the exhibit. Drag and drop the networking parameters from the left on to the correct values on the right.

正解：

解説：

Explanation:
The "ip route" and "ip addr show eth1" are Linux commands.
+ "ip route": display the routing table
+ "ip addr show eth1": get depth information (only on eth1 interface) about your network interfaces like IP Address, MAC Address information

質問 # 283
Drag the descriptions of device management from the left onto the types of device management on the right.

正解：

解説：

Explanation

Cisco DNA Center Device Management
3. Monitor the cloud for software update
5. Uses CLI templates to apply a consistent configuration to multiple devices at an individual location
6. Uses NetFlow to analyse potential security threats throughout the network and take appropriate action on that traffic Traditional device management
2. Manages device configuration on a per-device basis
4. Security is managed near the perimeter of the network with firewalls, VPNs, and IPS
* Implements changes via an SSH terminal

質問 # 284
Refer to the exhibit.

An IP subnet must be configured on each router that provides enough addresses for the number of assigned hosts and anticipates no more than 10% growth for now hosts. Which configuration script must be used?