更新されたPDF(2022年最新)実際にあるCisco 200-301試験問題 [Q48-Q65]

Share

更新されたPDF(2022年最新)実際にあるCisco 200-301試験問題

検証済みの200-301試験問題集PDF[2022年最新] 成功の秘訣はGoShiken


Cisco 200-301 認定試験の出題範囲:

トピック出題範囲
トピック 1
  • Identify Interface And Cable Issues
  • Compare Physical Interface And Cabling Types
トピック 2
  • Explain The Function Of SNMP In Network Operations
  • Explain The Role Of DHCP And DNS Within The Network
トピック 3
  • Describe Switching Concepts
  • Describe Wireless Principles
  • Nonoverlapping Wi-Fi Channels
トピック 4
  • Configure And Verify (Layer 2
  • Layer 3) Etherchannel (LACP)
  • Describe Physical Infrastructure Connections Of WLAN Components
トピック 5
  • Configure And Verify Ipv4 Addressing And Subnetting
  • Configure And Verify Ipv6 Addressing And Prefix
トピック 6
  • Describe Characteristics Of Network Topology Architectures
  • Compare Ipv6 Address Types
トピック 7
  • Compare Cisco Wireless Architectures And AP Modes
  • Configure And Verify Interswitch Connectivity
トピック 8
  • Configure And Verify Ipv4 And Ipv6 Static Routing
  • Describe The Capabilities And Function Of TFTP
  • FTP In The Network
トピック 9
  • Describe The Purpose Of First Hop Redundancy Protocol
  • Interpret The Components Of Routing Table
トピック 10
  • Differentiate Authentication, Authorization, And Accounting Concepts
  • Configure Device Access Control Using Local Passwords
トピック 11
  • Describe The Use Of Syslog Features Including Facilities And Levels
  • Configure And Verify NTP Operating In A Client And Server Mode
トピック 12
  • Configure WLAN Using WPA2 PSK Using The GUI
  • Describe Remote Access And Site-To-Site Vpns
トピック 13
  • Configure And Verify Layer 2 Discovery Protocols (Cisco Discovery Protocol And LLDP)
トピック 14
  • Explain The Forwarding Per-Hop Behavior
  • Configure And Verify DHCP Client And Relay
トピック 15
  • Describe AP And WLC Management Access Connections
  • Configure And Verify Vlans (Normal Range) Spanning Multiple Switches
トピック 16
  • Explain Virtualization Fundamentals (Virtual Machines)
  • Explain The Role And Function Of Network Components
トピック 17
  • Configure Network Devices For Remote Access Using SSH
  • Configure And Verify Inside Source NAT Using Static And Pools
トピック 18
  • Describe Wireless Security Protocols (WPA, WPA2, And WPA3)
  • Configure And Verify Access Control Lists
トピック 19
  • Verify IP Parameters For Client OS (Windows, Mac OS, Linux)
  • Describe The Need For Private Ipv4 Addressing

 

質問 48
What is true about DTP? (Choose Three.)

  • A. enabled by default
  • B. Proprietary protocol
  • C. disabled by default
  • D. Layer 2 protocol
  • E. Layer 3 protocol

正解: A,B,D

 

質問 49
Drag the IPv6 DNS record types from the left onto the description on the right.

正解:

解説:

Explanation

https://ns1.com/resources/dns-types-records-servers-and-queries#:~:text=Address%20Mapping%20record%20(A

 

質問 50
Refer to the exhibit.

Which prefix does Router 1 use for traffic to Host A?

  • A. 10.10.13.0/25
  • B. 10.10.13.144/28
  • C. 10.10.10.0/28
  • D. 10.10.13.208/29

正解: D

解説:
Explanation
Host A address fall within the address range. However, if more than one route to the same subnet exist (router will use the longest stick match, which match more specific route to the subnet). If there are route
10.10.13.192/26 and 10.10.13.208/29, the router will forward the packet to /29 rather than /28.

 

質問 51
Router A learns the same route from two different neighbors, one of the neighbor routers is an OSPF neighbor and the other is an EIGRP neighbor. What is the administrative distance of the route that will be installed in the routing table?

  • A. 0
  • B. 1
  • C. 2
  • D. 3

正解: C

 

質問 52
Which two statements about IGP and EGP routing protocols are true? (Choose two)

  • A. EGP routing protocols are used to connect multiple IGP networks.
  • B. OSPF, EIGRP, and BGP are categorized as IGP routing protocols
  • C. IGP routing protocols are used within internal networks.
  • D. Service providers use OSPF and IS-IS for intra-AS routing
  • E. Service providers use EGP and BGP for intra- AS routing.

正解: A,D

 

質問 53
Refer to the exhibit.

Which command provides this output?

  • A. show cdp neighbor
  • B. show ip interface
  • C. show ip route
  • D. show interface

正解: A

 

質問 54
Refer to the exhibit.

Which switch becomes the root bridge?

  • A. S2
  • B. S4
  • C. S3
  • D. S1

正解: A

 

質問 55
Refer to the exhibit.

All switch ports are assigned to the correct VLANs, but none of the hosts connected to SwitchA can communicate with hosts in the same VLAN connected to SwitchB.
Based on the output shown, what is the most likely problem?

  • A. The link between the switches is configured in the wrong VLAN.
  • B. Switch IP addresses must be configured in order for traffic to be forwarded between the switches
  • C. The access link needs to be configured in multiple VLANs.
  • D. VTP is not configured to carry VLAN information between the switches.
  • E. The link between the switches needs to be configured as a trunk.

正解: E

 

質問 56
Refer to the exhibit.

An engineer is tasked with verifying network configuration parameters on a client workstation to report back to the team lead. Drag and drop the node identifiers from the left onto the network parameters on the right.

正解:

解説:

 

質問 57
Which benefit does controller-based networking provide versus traditional networking?

  • A. combines control and data plane functionality on a single device to minimize latency
  • B. provides an added layer of security to protect from DDoS attacks
  • C. allows configuration and monitoring of the network from one centralized port
  • D. moves from a two-tier to a three-tier network architecture to provide maximum redundancy

正解: C

 

質問 58
Refer to Exhibit. How does SW2 interact with other switches in this VTP domain?

  • A. It transmits and processes VTP updates from any VTP Clients on the network on its trunk ports
  • B. It forwards only the VTP advertisements that it receives on its trunk ports.
  • C. It receives updates from all VTP servers and forwards all locally configured VLANs out all trunk ports
  • D. It processes VTP updates from any VTP clients on the network on its access ports.

正解: B

解説:
The VTP mode of SW2 is transparent so it only forwards the VTP updates it receives to its trunk links without processing them.

 

質問 59
Which QoS Profile is selected in the GUI when configuring a voice over WLAN deployment?

  • A. Gold
  • B. Silver
  • C. Bronze
  • D. Platinum

正解: D

解説:
Cisco Unified Wireless Network solution WLANs support four levels of QoS: Platinum/Voice, Gold/Video, Silver/Best Effort (default), and Bronze/Background.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/ consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_01010111.html

 

質問 60
Refer to the exhibit.

If the network environment is operating normally, which type of device must be connected to interface FastEthernet 0/1?

  • A. PC
  • B. router
  • C. DHCP client
  • D. access point

正解: C

 

質問 61
Refer to the exhibit.

Which switch becomes the root bridge?

  • A. S2
  • B. S4
  • C. S3
  • D. S1

正解: A

 

質問 62
Which statement about LLDP is true?

  • A. It runs over the transport layer.
  • B. The LLDP update frequency is a fixed value.
  • C. It is configured in global configuration mode.
  • D. It is a Cisco proprietary protocol.

正解: C

解説:
Section: Network Access

 

質問 63
which two values must you specify to perform an ACL-based Path Trace using APIC-EM? (choose two)

  • A. source interface
  • B. destination IP address
  • C. source port
  • D. source IP address
  • E. destination port

正解: B,D

 

質問 64
Drag and Drop Question
Drag and drop the benefits of a cisco wireless Lan controller from the left onto the correct examples on the right.

正解:

解説:

 

質問 65
......

ベストを体験せよ!200-301試験問題トレーニングを提供しています:https://www.goshiken.com/Cisco/200-301-mondaishu.html

練習サンプルと問題集と秘訣には2022年最新の200-301有効なテスト問題集:https://drive.google.com/open?id=1DYeyRcRVijLq3LOGjJE9uFsWTgrU3p87