結果を保証するには最新2022年01月無料Cisco 200-301で練習しよう
有効な問題最新版を無料で試そう200-301試験問題集解答
Cisco 200-301 認定試験の出題範囲:
トピック | 出題範囲 |
---|---|
トピック 1 |
|
トピック 2 |
|
トピック 3 |
|
トピック 4 |
|
トピック 5 |
|
トピック 6 |
|
トピック 7 |
|
トピック 8 |
|
トピック 9 |
|
トピック 10 |
|
トピック 11 |
|
トピック 12 |
|
トピック 13 |
|
トピック 14 |
|
トピック 15 |
|
質問 27
Which two statements about NTP operations are true? (Choose two.)
- A. Cisco routers can act only as NTP servers.
- B. Cisco routers can act as both NTP authoritative servers and NTP clients.
- C. Cisco routers can act only as NTP clients.
- D. NTP uses TCP over IP.
- E. NTP uses UDP over IP.
正解: B,E
質問 28
Which method does a connected trunk port use to tag VLAN traffic?
- A. IEEE 802 1D
- B. IEEE 802 1w
- C. IEEE 802 1Q
- D. IEEE 802 1p
正解: C
質問 29
Which IPv6 address is the all-router multicast group?
- A. FF02::4
- B. FF02::1
- C. FF02::2
- D. FF02::3
正解: C
質問 30
Refer to the exhibit. After the configuration is applied, the two routers fail to establish an OSPF neighbor relationship. what is the reason for the problem?
- A. The OSPF process IDs are mismatched.
- B. The OSPF router IDs are mismatched.
- C. The network statement on Router1 is misconfigured.
- D. Router2 is using the default hello timer.
正解: D
質問 31
Refer to the exhibit. The New York router is configured with static routes pointing to the Atlanta and Washington sites.
Which two tasks must be performed so that the Serial0/0/0 interfaces on the Atlanta and Washington routers can reach one another? (Choose two.)
- A. Configure the ipv6 route 2023::/126 2012::1 command on the Atlanta router.
- B. Configure the ipv6 route 2012::/126 2023::1 command on the Washington router
- C. Configure the ipv6 route 2023::/126 2012::2 command on the Atlanta router
- D. Configure the Ipv6 route 2012::/126 s0/0/0 command on the Atlanta router
- E. Configure the ipv6 route 2012::/126 2023::2 command on the Washington router
正解: D,E
質問 32
Drag and drop the QoS congestion management terms from the left onto the description on the right.
正解:
解説:
質問 33
How do you configure a hostname?
- A. Router (config)#hostname R1
正解: A
質問 34
What benefit does controller-based networking provide versus traditional networking?
- A. combines control and data plane functionality on a single device to minimize latency
- B. provides an added layer of security to protect from DDoS attacks
- C. allows configuration and monitoring of the network from one centralized point
- D. moves from a two-tier to a three-tier network architecture to provide maximum redundancy
正解: C
解説:
Section: Automation and Programmability
質問 35
How does QoS optimize voice traffic?
- A. by differentiating voice and video traffic
- B. reducing bandwidth usage
- C. by increasing jitter
- D. by reducing packet loss
正解: A
質問 36
Drag and drop the functions from the left onto the correct network components on the right
正解:
解説:
質問 37
Which type of attack is mitigated by dynamic ARP inspection?
- A. malware
- B. DDoS
- C. man-in-the-middle
- D. worm
正解: C
解説:
Section: Security Fundamentals
質問 38
What is the function of the command switchport trunk native vlan 999 on a switch?
- A. It designates VLAN 999 as the default for all unkown tagged traffic
- B. It creates a VLAN 999 interface.
- C. It designates VLAN 999 for untagged traffic
- D. It blocks VLAN 999 traffic from passing on the trunk.
正解: C
質問 39
Which configuration ensures that the switch is always the root for VLAN 750?
- A. Switch(config)#spanning-tree vlan 750 priority 38003685
- B. Switch(config)#spanning-tree vlan 750 priority 614440
- C. Switch(config)#spanning-tree vlan 750 root primary
- D. Switch(config)#spanning-tree vlan 750 priority 0
正解: D
解説:
Although the spanning-tree vlan 10 root primary command will ensure a switch will have a bridge priority value lower than other bridges introduced to the network, the spanning-tree vlan 10 priority 0 command ensures the bridge priority takes precedence over all other priorities.
質問 40
Which two pieces of information can you determine from the output of the show ntp status command? (Choose two)
- A. whether the NTP peer is statically configured
- B. the NTP version number of the peer
- C. whether the clock is synchronized
- D. the IP address of the peer to which the clock is synchronized
- E. the configured NTP servers
正解: C,D
解説:
Below is the output of the "show ntp status" command. From this output we learn that R1 has a stratum of 10 and it is getting clock from 10.1.2.1.
質問 41
Refer to the exhibit.
Which outcome is expected when PC_A sends data to PC_B?
- A. The destination MAC address is replaced with ffff.ffff.ffff.
- B. The source and destination MAC addresses remain the same.
- C. The source MAC address is changed.
- D. The switch rewrites the source and destination MAC addresses with its own.
正解: B
質問 42
Which two actions influence the EIGRP route selection process? (Choose two)
- A. The advertised distance is calculated by a downstream neighbor to inform the local router of the bandwidth on the link
- B. The router calculates the reported distance by multiplying the delay on the exiting Interface by 256.
- C. The router calculates the best backup path to the destination route and assigns it as the feasible successor.
- D. The router must use the advertised distance as the metric for any given route
- E. The router calculates the feasible distance of all paths to the destination route
正解: A,B
質問 43
How does Cisco DNA Center gather data from the network?
- A. Network devices use different services like SNMP, syslog, and streaming telemetry to send data to the controller
- B. The Cisco CLI Analyzer tool gathers data from each licensed network device and streams it to the controller
- C. Devices use the call-home protocol to periodically send data to the controller
- D. Devices establish an IPsec tunnel to exchange data with the controller
正解: A
解説:
Section: Automation and Programmability
質問 44
Refer to the exhibit.
The show ip ospf interface command has been executed on R1 How is OSPF configured?
- A. The interface is not participating in OSPF
- B. The default Hello and Dead timers are in use
- C. A point-to-point network type is configured
- D. There are six OSPF neighbors on this interface
正解: B
質問 45
......
200-301ブレーン問題集PDF、Cisco 200-301試験問題詰合せ:https://www.goshiken.com/Cisco/200-301-mondaishu.html
2022年最新の200-301サンプル問題は信頼され続ける200-301テストエンジン:https://drive.google.com/open?id=1DYeyRcRVijLq3LOGjJE9uFsWTgrU3p87